1
Omega General Help / No heating/ tepid
« on: 07 October 2018, 12:04:30 »
Hi
I have searched through the topics and have found lots of help, but I need a bit more if possible.
I have very tepid heating. I have changed the HBV. I have flushed out the heater matrix. Both pipes running into the matrix are now hot but no heat.
I ask, the 2 pipes that run into the heater matrix, can you tell me their routing, where they go to?
The 3 pipes that go into the HBV, where do they go to?
Is it likely the heater matrix is defective? is this the last place to check or change.
I ask pipework routing just in case I put them on the wrong connectors.
The 2 pipes that go into the matrix, what is the item they go into after the matrix.
I cannot find a heater pipe layout plan
Many thanks
Mick
I have searched through the topics and have found lots of help, but I need a bit more if possible.
I have very tepid heating. I have changed the HBV. I have flushed out the heater matrix. Both pipes running into the matrix are now hot but no heat.
I ask, the 2 pipes that run into the heater matrix, can you tell me their routing, where they go to?
The 3 pipes that go into the HBV, where do they go to?
Is it likely the heater matrix is defective? is this the last place to check or change.
I ask pipework routing just in case I put them on the wrong connectors.
The 2 pipes that go into the matrix, what is the item they go into after the matrix.
I cannot find a heater pipe layout plan
Many thanks
Mick