Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - VXL V6

Pages: 1 2 3 4 5 6 7 [8] 9 10 11 12 13 14 15 ... 24
106
In good working order please.  :y

I have two here I really should repair, but the last time I tried to prize the casing off one I ended up launching it at the nearest wall!

107
General Car Chat / Another big thanks to Daz
« on: 16 August 2015, 20:29:01 »
For doing the Wishbones on the 2.6  :y

Top job as always and good to have a chat and a laugh. Next time i'll remember all the parts for the oil cooler reseal  ::) ;D


108
General Car Chat / LPG Kit Suppliers
« on: 08 August 2015, 18:26:45 »
Who is the best supplier of the Stag 300 kits now? As I understand it, Telio has gone out of favour with OOF a little?

Want to make sure I'm not paying too much for the kit as I've found a couple of suppliers but really don't know how much these kits should be retailing for.

109
Car Parts, bits For Sale & Wanted / WANTED: 3 button fob
« on: 15 June 2015, 12:58:11 »
Just the circuit board will do. No fussed about switches needing replacing or battery carrier needing re-soldering, as long as the board actually works and no one has previously repaired it.  :y

110
Car Parts, bits For Sale & Wanted / WANTED: Facelift MV6 bumper
« on: 12 June 2015, 22:44:46 »
Good condition please with towing eye cover.

Mesh, Foglights, temp sensor, loom and Washer jets not important as I already have them.

Have seen the one on Ebay but just seeing if there is another one out there, Z20R paint would be nice but not essential.

Many thanks

111
General Car Chat / Big Thanks to Essex Big Al
« on: 01 June 2015, 19:31:31 »
For supplying an excellent set of late Elite textured leather seats to replace the worn out set in my 2.6 (drivers seat sags and the beaded edge is coming away, heaters had started to melt though the back of the leather on both from seats). He even fitted them for me as well!!!

Also picked up a length of loom from injector loom plug back to the ECU so I can make up a pluggable LPG loom as well as the B pillar trim that was falling off mine!

Cheers Al

Much appreciated.  :y

112
General Discussion Area / New Hoover - Dog compatible!
« on: 22 March 2015, 12:50:01 »
Anyone have any recommendations for a decent hoover that can cope with mountains of dog hair?

Our Sprollie (Springer Collie X) is losing its winter coat and our two old Hoovers tend to block up halfway through hoovering a room.

113
Omega General Help / Squeak from rear suspension
« on: 05 March 2015, 19:56:25 »
I think it's actually the rear dust shields / handbrake return springs - when handbrake applied the rear squeaks when the suspension moves. ie when I get out of the car.

Is there a fix for this? I tried gently bending the dust shields and popping some grease on the springs but noise persists.

114
General Car Chat / Thoughts on my MP3 install please
« on: 12 February 2015, 19:50:52 »
Sorry for the poor quality phone picture



Head unit modified to take direct input  :y

115
Maintenance Guides / Scuttle Sealing - Photo
« on: 12 February 2015, 17:45:39 »
Here's where you seal the scuttle (scuttle removed) to stop it dripping water onto the N/S of the engine / dispack etc. I've just used some Loctite grey sealant as it was handy. You'll need to scrape the remains of the foam off this area and the corresponding part of the scuttle.


116
Omega Electrical and Audio Help / NCDC Sat Nav connector
« on: 12 February 2015, 17:29:42 »
Brain not working today!

What style connector is the Sat Nav antenna on an NCDC/R Head unit?

117
Car Parts, bits For Sale & Wanted / Wanted - Scuttle / washer parts
« on: 10 February 2015, 08:33:16 »
After a little incident this morning i'm after the following (need to check at home as I might already have most of the parts)

Washer jet wiring loom (under the scuttle to the plug on the N/S)
N/S scuttle panel (top)
Washer pipe from N/S to joint
Insignia washer jet
Heater unit for washer jet

118
General Car Chat / Big thanks to Daz
« on: 01 February 2015, 18:10:41 »
Another Cambelt kit and Auxbelt kit (inc waterpump and auxbelt tensioner and pulley) fitted to the 2.6 - It's only been 16 months since the last one  ::)

Top Job as always, cheers Daz, was good to see you again!  :y

119
Omega Electrical and Audio Help / Facelift / Prefacelift ashtrays
« on: 21 January 2015, 21:16:30 »
Question, the Facelift centre console ashtray has a four pin plug with three contacts wired, basically two live feeds and a 0v return. The switching for the illumination is obtained by a switch mounted in the rear of the ashtray assembly.

Looking at a pre-facelift ashtray there are four contacts wired on the same style plug. Does anyone know why? I presume the illumination switch isn't built into the ashtray on these models?

I ask for a valid reason!!!

120
Omega General Help / Rear adjusters
« on: 17 December 2014, 17:03:56 »
I'm presuming VX only?

Anyone have a part number and price?

Pages: 1 2 3 4 5 6 7 [8] 9 10 11 12 13 14 15 ... 24

Page created in 0.018 seconds with 17 queries.