Ah yes - I had supports turned on everywhere on my first Benchy .. he had no windows, or doors..
I've since fine-tuned the support settings so that I can actually get them out/off
except for one on my last print, which is annoying - I'll figure that out, though!
Re the temp tower and needing adjustment - the temperature tower was someone elses gcode (from the Chiron owners group) so no tweaking possible there; and nobody knows what slicer settings he used
but my own prints are starting to look better now:
(You can see the non-removable support in the hole at the lower left corner where the rotary encoder
should poke through)
There's some 'ringing' visible - I need to tighten the belts (which is why I'm currently printing new tensioners!) and add supports to the Z axis uprights.. though the support attachment blocks need 14hrs to print, so I'll do those bit-by-bit! If it's running overnight the noise will probably annoy the OH as my office is next-door to our bedroom (that was poorly planned, I should have bagsied one of the huge double bedrooms as my office
)
Oh, and I think I could probably go lower with the temperature - I'm already at 180ºC, but others have found the thermistor reads ~20-30ºC low so I could still be at 200ºC right now. Must dig out the IR thermometer.