Show Posts

46

Omega General Help / Re: Fog tail light

« on: 01 March 2018, 19:56:47 »

I checked those and there it was, Blue/Black was not completely cut but visible copper and Brown was cut.

Thanks!!

47

Omega General Help / Re: Fog tail light

« on: 28 February 2018, 14:58:48 »

Did you find solution? I haven't towed anything in a while but today as normal reversed out of garage and rear fog light indicator went on. However fog light isn't on when it does it. In drive or park everything works normally

48

Omega General Help / Re: Left on road MAF?

« on: 15 February 2018, 09:19:39 »

Measured ht leads, ok. Changed coil pack and spark plugs. No work

Ordered MAF, changed it and she runs well

Well atleast it's working now and also I have a spare coil pack and plugs were changed

49

Omega General Help / Re: Left on road MAF?

« on: 04 February 2018, 18:40:18 »

I surfed around internet and bumped into exactly similar story as mine (strobing EML light .etc) and the reason was broken coil pack, so I think my best choice of multiple ~100eur guesses is to choose the coil pack for starters....

50

Omega General Help / Re: Left on road MAF?

« on: 04 February 2018, 14:24:10 »

Okay, I dont have any tech 2 or so but if they are out of tune what needs to be done?

ICV=idle control valve? It is cleaned frequently anyway and last cleaning under a year ago but will do that. Also it's running roughly on higher rpms too.

51

Omega General Help / Re: Left on road MAF?

« on: 04 February 2018, 12:21:37 »

It's giving 14,1V and that is normal, atleast that is what it has always given

52

Omega General Help / Re: Left on road MAF?

« on: 04 February 2018, 10:26:22 »

MAF unplugged runs ok-ish yeah. I must admit I have never ever seen Omega running with engine light on so is it normal for it to like blink very quickly? It's like not glowing all the time it's blinking very high frequency.

Edit: now it runs with MAF plugged the same way as with it unplugged??

Is the crank sensor the one near oil filter?

53

Omega General Help / Left on road MAF?

« on: 04 February 2018, 09:45:42 »

Hey,

-99 MV6 left me on road

Traction control was working as I was accelerating hard and then power went down and then engine shutdown.

Paperclip gave
73 Mass Air Flow Sensor Voltage Low
74 Mass Air Flow Sensor Voltage High

Is this clear MAF case?

Engine is running roughly and will eventually shutdown. Starts but will not run.

Also it's about -15-20degrees in Finland now and I filled her up 10min before incident. (Had to check from receipt if I put diesel into her but luckily no

)

54

Omega General Help / Re: Front Strut Top hat alignment

« on: 30 January 2018, 20:26:55 »

Solved the on my car, it was the strut mount. Washers were in really good condition. Bigger hole came over tire and smaller over stabilizer bar.

55

Omega General Help / Re: MV6 Front suspension top mount

« on: 30 January 2018, 20:20:42 »

YESSS

It was the strut mount.

The arrows shows one main reason, that metal part comes longer downwards on the old one so the washer will only press the metal part up and will not hit the rubber itself.
In the new one the washer will press evenly the rubber and the metal part.

56

Omega General Help / Re: Front Strut Top hat alignment

« on: 30 January 2018, 05:21:54 »

What would I do without you all

I'll drive carefully untill I get this done and will get back after I have found the reason.

57

Omega General Help / Re: Front Strut Top hat alignment

« on: 29 January 2018, 07:05:36 »

This happened me last year. Something started to make noise in front after changing shock absorbers. My findings was that the outside of the #2 on the picture was hitting the arch. This may be also caused by the problem I have now (huge cap between arch and top plate) but anyhow I didn't turn the #2 I only took hammer and hammered it down 2mm and that did the trick. Next time I'll know to turn it to right position

58