Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - cam.in.head

Pages: 1 [2] 3
16
Car Parts, bits For Sale & Wanted / z157 panels
« on: 23 June 2020, 16:10:58 »
hi.all. looking for a perfect condition( fittable without needing painting) bonnet ,boot lid,and possibly rear bumper in z157 please. im located west yorks so closer the better !
many thanks.

17
Omega General Help / belt length
« on: 24 May 2020, 20:59:36 »
hi there. what length of belt do i need for my 2.6 v6 to not use the aircon compressor please ?

18
Omega General Help / code1612
« on: 22 May 2020, 17:50:53 »
hi to all.
my omega 2.6 has been running fine .no issues with any fault lights .
normally when starting i wait for the lights to partly go out before turning over,today i inserted key and turned it over immediately. car started straight away then stalled.
 tried again normally ,started fine ,been fine all day and no fault lights on except pedal test now shows 1612. running fine ,starting fine .
spanner light stays on (solid) and doesnt go out initially like it did before. untill engine started then goes out and stays out.
chip in key is still present and not loose.
how can i reset spanner light back to no faults( constant flashing on pedal test)

19
Car Parts, bits For Sale & Wanted / Alternator front half case
« on: 15 January 2019, 18:11:33 »
Hi there. Rebuilding my alternator and noticed the front case has a crack in it. It’s on a v6 and is the bosch type with the 1” gap between the casing halves  if anyone has one please ? .
Many thanks.

20
General Discussion Area / Panasonic plasma main board question
« on: 07 January 2019, 16:17:24 »
Hi. One of my recent hobbies is with plasma tv,s  mainly panasonic.
One question regarding the reset issue on some models. In this instance the TX-P50U30B.( beleive also the S20/21range too)
Ive had two  or 3 now with the clicking/ non turn on issue ,reset with the remote power button and set power button.all ok for a few weeks with no issues.then can happen again out of the blue.
Replacing the main board solves the issue .
So my question is .....what is the offending part on the main board that causes this?. I beleive the Samsung r86,87 range had similar issues caused by the eeprom ?
 Sorry to you proper tv engineers. Still learning all this

21
Car Parts, bits For Sale & Wanted / Z157 bonnet
« on: 19 July 2018, 11:18:07 »
Hi. Anyone got a silver z157 bonnet in excellent fittable condition(still on a car if pos or stored correctly ,no chipped corners )as an alternative to having mine resprayed.as local to bradford as poss.to drive to and swap over .many thanks.

22
General Discussion Area / any tv engineers here please
« on: 08 March 2018, 14:42:22 »
for anyone who knows the panasonic tx-p50xt50 and similar styles they suffer from the u203 chip causing a loss of power. i oredered a fan6755u to replace it and found the exact same chip already in there.a fairchild one.   replaced it anyway and put set back together. all fired up fine and worked all evening without issue.next morning tv was dead.i always turn mains off at night and dont leave anything on standby.
ordered another fan chip just incase the other was faulty and will fit it when it comes.
questions i have are
what does this chip actually control and can it be bypassed ? .
can you bypass the power button (is it just a flip fliop ? )
can i run an additional 5v stby to this circuit?
anything else to check/ replace ?
many thanks.

23
Omega Electrical and Audio Help / usb music
« on: 13 October 2017, 12:23:34 »
has anyone tried any of the usb memory stick players . designed to work on any car with a cig lighter socket and fm radio .they seem to start from about six quid but not sure if thats only a usb charger function version.

24
Omega General Help / Crankshaft bolt
« on: 30 July 2017, 16:57:24 »
Hi. Can someone please advise part number for v6 front crank pulley bolt please.(centre)many thanks

25
General Car Chat / NVH
« on: 11 July 2017, 16:56:41 »
hi. heres a question for you. ive posted this on a few other forums to compare what answers i get though it doesnt realy apply to omegas. take one standard saloon car from say the seventies and once its all rust free and wayoyled up it looks good and hopefully will remain that way for years to come.each year you go underneath and check everywhere thoroughly and repair / re underseal as necesarry if required. then maybee every 5 years or so one extra coat of waxoyl to make it all look even again. (i say waxoyl but can be the sealer of your choice ,dinitrol,whatever,etc)now i have done this for the last 30 years to my cars and have noticed that they are all very gradually getting noisier .aside from the fact that you are in theory putting more sound deadening on you are also building up the thickness of the panels/floor and i suppose lowering the natural resonant frequency and making the car feel louder at low frequencies.(hard to explain,boomier,thumpier !for want of better descriptions!)i have read many a website on this subject and realise it is a big thing that manufacturers spend millions to get right on new cars and a much misunderstood and underrated subject. so aside from removing all my years of protection and appliying just one layer like it was before originally .has anyone any suggestions/ experience of this type of thing.

26
Car Parts, bits For Sale & Wanted / goodyear excellence
« on: 28 June 2017, 12:43:01 »
hi. if anyone is interested before i list it on ebay i have a new /unused goodyear excellence tyre          225 55 zr16. or if anyone has another new matching tyre il buy that off you.

27
Car Parts, bits For Sale & Wanted / v6 front crank oil seal
« on: 27 June 2017, 20:55:30 »
hi. anybody got a new one for sale please . many thanks

28
Omega General Help / seats swap
« on: 22 June 2017, 14:09:59 »
hi all. as some may know i have been looking for some cloth seats to replace the leather in mine .am i right in assuming if the new seats come from a cd model they will still be plug and play(less passenger seat height adjuster)no changes between a 2000 model year and a 2003 with ref to putting them straight in / not touching airbags/ battery disconnected etc.thanks

29
Omega General Help / Elite suspension
« on: 29 May 2017, 15:56:31 »
Hi .i keep reading about how the elite suspension is nice and soft compared to the other models. Mine is a 2003 cdx in standard spec with standard gm dampers and front springs(rears are new kyb thou ) .what are the differences if any that make the elite softer ? . I personally thought it would have only been the mv6 models that would have a different setup ? ??

30
Car Parts, bits For Sale & Wanted / floor mat retainers
« on: 12 May 2017, 16:41:07 »
hi. anyone got any mat securing screws they could part with please ? .i need 5 . many thanks. chris.

Pages: 1 [2] 3

Page created in 0.043 seconds with 14 queries.