Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Vectrahed

Pages: [1] 2
1
Omega General Help / Re: looking for help\advise please ?
« on: 11 June 2019, 21:48:46 »
if you can, read the stored fault codes ,just in case  :y

Crank sensor :-\

That said, it would still crank...

The Omega can be a bit sensitive if you throw the key in and try to crank it immediately. Possibly a sign that the ignition switch is on its way out :-\

Had an astra that the tip of the ignition barrel spindle snapped off in the switch ,also had an ignition switch with burnt out contact pad on another car  :y


Have no way to read codes mate

2
Omega General Help / Re: looking for help\advise please ?
« on: 11 June 2019, 21:30:35 »
ID40 chip in the key ? was the spanner light flashing when you tried to crank it ?(immobilizer)
remove key from keyring if you have other keys and fobs on ,try key both ways up
could also be a duff starter solenoid


Im even more stumped now haha the bloody thing only went and started up just there, ran it for a few mins up and down the road, took it back underground and switched it off. started it a second time and it fired up as per norm  ???

3
Omega General Help / looking for help\advise please ?
« on: 11 June 2019, 20:53:10 »
Hi all. vectra 2.5 v6 question if anyone can help.

have been doing bits to the car over the last few weeks, last thing i replaced was a solanoid valve on the inlet. car started as normal after that.

next day i took the car out of the underground carpark and parked it outside my apartment all was fine.

2 hours later it wouldnt start. battery is fine but the engine made no sound at all, did not even try to turn over, dead as a dodo as they say.

I removed the battery, had a fiddle here and there, battery back in and it tried to turn over but seems something is not letting it fire into life.

now this did happen before and i just removed the battery for a few mins and when put it back it started fine but as mentioned it just wont fire up now and has me stumped

hope to get some help as to where to start looking

Thanks

4
Omega General Help / Re: advise on this please ?
« on: 27 May 2019, 17:28:52 »
all good i found its location.

5
Omega General Help / advise on this please ?
« on: 27 May 2019, 12:56:11 »
Hi. Can anyone tell me where this is to be connected to on 2.5 v6 vectra please ?



thank you


6
Just go to any hydraulic hose repair place,or ebay, they do acrylic air hose different colours and bore size, think that pipe is 4mm.

Hi mate, cheers for the reply. ive been looking on ebeay there, nice bloody prices  ;D


would there be a how 2 on here changing the harder pipes if things need to be disconnected ?

Thanks

7
Very nice :y :y

The trouble is when I see white cars I think of weddings, lovely dress, gorgeous bloke....................damn, the bubbles burst again! :'( :'(


Thank you  :y   are you single then haha  ;)

Yes, now I am. :'( :'(..................but now I have my freedom back! 8) :D ;)


haha thats it, time for some enjoyment for you hey  :y

8
Very nice :y :y

The trouble is when I see white cars I think of weddings, lovely dress, gorgeous bloke....................damn, the bubbles burst again! :'( :'(


Thank you  :y   are you single then haha  ;)

9
General Car Chat / Vectra B 2.5 v6 engine pipes replacement.
« on: 22 May 2019, 19:33:46 »
Hi all. im doing some work on a 2.5 v6 preface vectra B engine and i need to replace a few pipes if anyone can tell me what each pipe is called please.

Ive seen a few pictures of same engines with the coloured pipes, red, yellow etc and imm thinking of maybe i should get myself a nice set but to be fair i wouldnt really know where to begin and id probably end up buying the wrong pipes haha hoping to get some advice also on the thin pipe the looks like its melted, not sure where it suppose to go either. hope yous can help

thanks










10
haha was just a test to see if i could use it  ;) figured it out now though so ill put another post together with proper pictures this time  ;D

11
They look very nice :y Did you deliberately set out to buy white ones or was it a case of what was available at the time?White does seem to suit them.

Hi mate. cheers, yes i love the white too but It was just how it turned out tbh. Id bought the vec c last year and only picked up the B a couple of months ago when i came across it. my first 2.5 and it needed the rocker gaskets changed so ive got stuck into myself but still bits to sort out

12
Omega Gallery / My Vectra C 1.8 SRI and Vectra B 2.5 v6 SRI
« on: 21 May 2019, 22:19:08 »



13
Newbie Welcome Area / Re: Vectra B 2.5 v6 saying hello
« on: 21 May 2019, 21:34:54 »


not many pictures on my laptop but will try get some on

15
Newbie Welcome Area / Re: Vectra B 2.5 v6 saying hello
« on: 21 May 2019, 21:20:20 »
thank you very much

Pages: [1] 2

Page created in 0.024 seconds with 19 queries.