For about the last few weeks almost on every ignition start the brake pad wear warning message has appeared on the display,despite no wear sensor being fitted for the last 18 months and both wires soldered and heat sealed together.The message can be cleared and doesnt every reappear whilst driving so it would seem the sensor wire bridge isnt at fault.
Yesterday as part of my scheduled plan both sets of front brake pads were replaced,and whilst I was in the nearside wheel arch I decided to have another look at the wiring.Just to be belt,n,braces I recut the sensor wire and again resoldered and heat shrunk the connection.
This morning went out to work and on start again the pad wear sensor message appeared and has continued as before only appearing on a ignition start.
Is is possible to totally disable this within the relay/loom or fuses as its now starting to do my head in.
Cant see and damaged wires from the plug up into the point where it dissapears into the loom inside the inner wing.
Help please