Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Boiler Man

Pages: [1] 2 3 4
1
Omega General Help / 2.2 dti fuel leak around diff area
« on: 17 January 2022, 15:20:50 »
Hi Guys

Hoping for a bit of advice please.
My 02 - 2.2 dti estate has suddenly developed a fuel leak. It is dripping off the rear diff only when the engine is running.

I haven't managed to get it off the ground yet to have a look, but wondered if the fuel lines run over the diff from the tank or does anyone have a diagram of the fuel line route.

TIA.

2
Omega General Help / Estate Rear Light
« on: 05 October 2017, 11:22:52 »
Hi Guys

Could anyone please tell me if the rear light cluster on the estates are all the same.

I have an 02 model that someone has knocked and damaged.

I have looked on fleabay but some look slightly different on the clear lens.

Any advice would be much appreciated. :y

Cheers
Gary

3
Omega General Help / Dti Fuel Pump Problem
« on: 16 May 2016, 14:58:32 »
Hi Guys

I wondered if someone could help me please with a some advice.

I have replaced my seized 2.2 dti engine with a good 2nd hand one I bought a while back.

Its a long story but.
We are having problems with the fuel pump on the replacement engine feeding fuel to the injectors and I have heard it is because of the security coding with the car and the replacement engine.

Is this the case and is there a way around it?

Any advice would be very much appreciated.
 :y

Thanks in anticipation.
Gary

4
Omega General Help / 2.2 Dti Vacuum Pipes
« on: 07 September 2014, 11:34:01 »
Hi Guys

Just hoping someone can help me please. I'm looking for a diagram of the vacuum pipes for 2.2 dti.

We have just finished replacing the engine with a good 2nd hand one I bought off Joff a couple of month ago.

It's a long story, but it is now in and running pretty good, it will run all day if not pushed.

However it seems a bit short on power and when accelerated hard the EML comes on and it drops into limp mode, until the engine is switched off and restarted.

We suspect a vacuum pipe has been put back incorrectly. I have had this problem nearly every time I have had jobs done on the dti, but usually I find a loose or disconnected vac pipe. :(

Any help would be very much appreciated. :y

Cheers Gary

5
Omega General Help / 2.2 Dti has come to a grinding holt:-(
« on: 22 June 2014, 01:27:30 »
Hi Guys

I am in need of some advice please.

Has anyone had or heard of a dti 2.2 chain to go?

On Friday my trusty steed an 03 which has done 230k suddenly crunched, engine stopped all dash lights came on. I quickly pushed in the clutch and coasted to the side. The AA arrived asked me to try and turn over the engine out of and then in gear.

Against my better judgement I carried this out and just heard a clunk with no turnover of the engine. I've had the car moved to a garage and as it was late Friday afternoon it won't be looked at until Monday.

I suspect the chain has gone, I maybe grasping at straws, but could it be anything else?

Any advice would be much appreciated.

Cheers Gary

6
Omega General Help / Brake Master Cylinder
« on: 02 July 2013, 09:50:54 »
Hi Guys

My older S Reg 2 ltr Dti has failed the mot on brake pedal travelling near to the floor and dropping as the engine idles.

I'm thinking master cylinder.

Could anyone tell me if the master cylinders are all the same, or do I need to look for one to my specific year/engine size?

Any advice would be very much appreciated. :y

Cheers Gary

7
Omega General Help / Auxiliary Belt Diagram - 2.2 Dti
« on: 16 March 2012, 17:44:16 »
Hi Guys

Hope someone can help.

I have had problems with my Aux Belt Tensioner. 2.2 Dti

Now sorted.

But I could do with a Diagram or Photo of the route of the belt. I have tried all sorts of ways and have loads of spare belt.

I'm sure it's simple, but I can't figure it out. :-\

I had a diagram at one time, but can't find it now.

Can anyone help please. :y

8
Hi Guys

Hoping for a bit of advice please.

The other day heard a clunck and my Auxilary Belt slackened off. No Alternater, No Power steering etc

Found that the belt tensioner had come adrift because the top bolt holding it on had sheared off, vertually flush with the bracket :(

I have tried to drill a hole in the bolt with a right angled drill extension, thinking I could try a stud extractor in it.

But it is proving near impossable, what with the radiator and A/C pipes in the way.

It looks like the bracket that the bolt has sheared from is holding on the, what I would call the A/C condensor pump.

Does anyone know if this can be removed with or without the pump.

Or if anyone has an exploded view of the 2.2 Dti Engine.

It would be very much appreciated. I'm getting a bit desperate :o

Cheers Gary

9
Omega Electrical and Audio Help / Vision FM Stereo Modulator
« on: 18 November 2011, 13:52:33 »
Hi Guys

Sorry if this has been covered before. I have done searches, but not really come up with anything.

After reading a few threads on the subject I have just purchased a Vision FM modulator from DND Services.

Looks pretty straight forward install.

But I was looking for advice from any of you who have fitted one in their Omega's.

Where is the best place to position the device in the miggy and where is the best place to pick up the power.

I'm positioning my iphone right of the Steering wheel on a vent mount.

Any help or pic's would be very much appreciated.  :y

Thanks In Anticipation Gary.

10
Omega Electrical and Audio Help / CAR300 Code
« on: 28 September 2009, 18:45:18 »
Hi Guys

Wondered if someone could help me please.

I'm trying to put the code into my old CAR300 Radio.

I've done it plenty of times in the past no probs. But I'm struggling this time with the code.

On my Car Pass there appears to be two codes.

On line 2 next to Security Code a 4 digit number i.e. ****
and line 5 below I have a title Radio Type/Code or i.e. 0500 / ****

Can anyone tell me which I use as I've had 3 knockbacks already and I'm getting nervious. :o

Cheers

11
Hi Guys

I have bought an after market Towbar for my Facelift Estate 2003.

I'm not great with auto electrics so help would be appreciated.

With the kit I have a single electrics socket kit 12 N & The 7 way bypass relay wiring kit recommended by the supplier, Towequipe.

I've read quit a few of the posts on here on the topic, but I'm still confused.

Will the by pass kit I've bought do the job or do I still need a adaptor plug for the socket and another relay to replace the the existing indicator relay?  :-/

Any advice would be great.  :y

12
Omega Electrical and Audio Help / Panel bulbs
« on: 31 July 2006, 21:07:54 »
Hi guys

Can anyone help me on the bulb details for the instrument panel and roughly how many, some of mine have either given up or going dim.

The car is a pre facelift s reg. I've looked on the chart at Hal's but it's not clear seems to suggest 2 or 3 differant types.

Don't really want to pull out the dash then find I can't get them straight away.

Any help appreciated

13
Omega Electrical and Audio Help / Quick xenon Question
« on: 17 November 2006, 00:35:15 »
Hi Guys

I'm trying to find my way around my new facelift motor. Dont have Xenon's on old Omega which had an adjustment wheel to alter the level manually.

1. Apart from the obvious ie the beam seems in the correct place, how can you tell if they are leveling or adjusting correctly?

2. Is it normal for them to wobble a little when you go over a pot hole?

Any advice would be appreciated, just a bit concerned, I cant see anything happening, after having full control on my pre facelift gls.

14
Omega Electrical and Audio Help / Where to put the Parrot
« on: 19 November 2006, 21:13:32 »
Hi Guys

Looking for some more advice and photo's if pos' hope you can help.

I've decided after all your great advice, to go for the Parrot phone kit, proberbly the new one the 3200. In to a 2003 Facelift.

My question is where best to put it and what bracket to use. Ideally I'd like it fairly close, ( the old bins are going a bit now)  so dont want to be squinting at the thing, but dont want to obstruct anything important. Ideally I dont want to be drilling holes in the dash etc or cables hanging every where.

So if any of you chaps have found the best spot for your kit, I'd really appreciate it and any photos.

Ps I know a couple of you have already suggested their profered place, but could do with a bit more detail.

Cheers :y

15
Omega Electrical and Audio Help / Phone pre-wiring
« on: 12 November 2006, 23:37:32 »
Hi Guys

Can anyone advise me. On the later facelift models the sales lit says that the omega has factory fitted telephone pre-wiring, the car I have in mind has a CCR 2006 and is an 03.

How do you go about fitting a current modile phone into this? Will it work with the cars display and can you use a cradle plug in type holder? I dont want to use blue tooth as I am in and out of the car all day. Not only does it drive me mad disconnecting and reconnecting bluetoth, but it also drains the phone battery with bluetooth on all the time.

Thanks, any help would be realy appreciated, I'm a bit of a numpty when it comes to car wiring and interfacing.

Pages: [1] 2 3 4

Page created in 0.036 seconds with 17 queries.