Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - grifter

Pages: 1 ... 28 29 30 31 32 33 34 [35] 36 37 38 39 40 41 42 ... 62
511
Omega General Help / Re: tech 2
« on: 29 March 2018, 13:15:32 »
Autovaux in East Kilbride do tech 1&2

512
General Car Chat / spotted silver saloon m8 glasgow airport
« on: 28 March 2018, 10:36:49 »
Seen yestetday about half 4, Westbound at glasgow airport. It was a bit ahead and i was turning off a737, but managed to see it was 03 plate, looked good nick likely a cd model.

Ps do we have a spotted thread in here ?

513
General Car Chat / Re: Is it just me
« on: 28 March 2018, 07:50:10 »
http://www.bbc.co.uk/news/uk-13143206

Well done that guy, hlights far too bright on a lot of cars, you can actually feel a laser focused pain to the back of eye with dazzle from these lights.

514
Omega General Help / Re: stalled
« on: 25 March 2018, 20:08:49 »
The plug that goes onto the maf (i think) was broke, i knew about this but it still slotted it quite firmly, is now tie wrapped tight into the plug & loanbehold the light on dash (eml) is now out!

515
General Discussion Area / Re: Potholes
« on: 25 March 2018, 20:05:52 »
If my understanding is correct aren't road surfaces about 90% rough aggregate, shredded glass and the tar is just a "glue" to hold it all together. I think they might be using cornflakes and weetabix as the aggregate now!

516
General Discussion Area / Re: Potholes
« on: 23 March 2018, 13:20:27 »
Its not even just potholes, whole roads are wearing away because they dont use high quality tar and relaying procedures, they just rough the surface up and put a light skim of crumble mix over the top. The stones are tiny in it, they wash out and cars goin over them doesn't help, add in rain, frost and all the rest and you end up with the old road surface "resurfacing" after a couple of months.

Also have you noticed how many blocked drains there are. The councils dont clean em anymore, they dont sweep the gutters in autumn either, adding to the blockage problem.

517
General Discussion Area / Is this the end of VX
« on: 23 March 2018, 13:13:20 »

518
Omega General Help / Re: Wishbone front bush removal tool
« on: 21 March 2018, 10:38:08 »
Hammer out bush with big socket/drift then hacksaw the collar

519
Omega General Help / Re: Breather Bridge Seals and Cam Gaskets
« on: 21 March 2018, 10:36:25 »
Got a breather bridge seal from autovaux

520
Omega General Help / Re: stalled
« on: 20 March 2018, 19:59:07 »
Presumably the fuel pressure regulator vacuum line is still connected to the bottom of the throttle body?

That is the pipe that comes along the middle of the banks and plugs up the way into the body, if so yes I've checked all the vac lines all around there and on the multi-ram bits as well.

521
Omega General Help / Re: stalled
« on: 20 March 2018, 18:11:19 »
I don't mean to be rude, but if you don't know what a MAF looks like or where it is, I'd probably get some help.

Anyway, as well as the above suggestions, look for split pipes (air to plenum) and split vacuum pipe end. Also, it is worth checking the throttle body to see if it's gunked up.

It's no prblem i know where it is. I just put that all back together last year after doing timing belt. Everything looks fine but will check agsin. If i dont see anything obvious what is next step with maf?


if you had the tech, tools and experience you could examine how well it is functioning.


As you don't have those, disconnect the electrical connector on the MAF, and drive the car. This will put the EML on, but if the actual problem is no longer present then buying a quality new MAF is your next step.


But you're already breaking the first rule of diagnosis by not going back over the work you did before the fault.

If you mean the timing belt work, that was done about a year ago and have checked this area multiple times, and once more tonight.

Going by this advice I unplugged the maf multi plug (the one under the left air intake bagpipe thing right?) and the car struggled to start and when it did the gearbox seemed to lock into a high gear and it wouldn't move. So I guess that didn't work either. I then plugged it back in and the car ran fine.

I have a friendly contact in the AA who has said that he can check it. I don't know if this will give a diagnosis or just codes, but it won't hurt, my 2nd option is a guy who does tech2 near Glasgow. I will take it there and see what if anything they can find as this is doing my brain in now.

522
Omega General Help / Re: stalled
« on: 20 March 2018, 10:48:21 »
I don't mean to be rude, but if you don't know what a MAF looks like or where it is, I'd probably get some help.

Anyway, as well as the above suggestions, look for split pipes (air to plenum) and split vacuum pipe end. Also, it is worth checking the throttle body to see if it's gunked up.

It's no prblem i know where it is. I just put that all back together last year after doing timing belt. Everything looks fine but will check agsin. If i dont see anything obvious what is next step with maf?

523
Omega General Help / Re: Failed MOT advice (Emissions)
« on: 20 March 2018, 07:05:44 »
New MOT document comes into force on 2th May:

https://www.gov.uk/government/publications/mot-inspection-manual-for-class-3-4-5-and-7-vehicles

Currently the draft shows an EML lit as a major fail. ::)

There is nothing in the MOT manual that requires or allows connection to an OBD port so I'd be having a word if they tried that on my car. It's possible that emissions testers designed for the european market have the interface fitted but it's not used in a UK MOT test.

This has been a fail point for a while. People used to take the bulb out to get through mot.

524
Omega General Help / Re: stalled
« on: 20 March 2018, 06:45:58 »
If by a guide you mean, "unplug it and see if anything changes..." then yes, there's a guide ;)

No, how to actually change it lol :)! I found it anyway but cheers

Got to take scuttle off again bummer, is there anything on this car that doesn't require that bloody scuttle removed?

525
Omega General Help / Re: stalled
« on: 19 March 2018, 20:14:41 »
If Fuse 19 is advising MAF, then I would be looking there before anywhere else. Unplug the MAF and see if the symptoms change.

Is there a guide for doing this?

Can you read the live values for air flow and the learnt values for mixture?

Pages: 1 ... 28 29 30 31 32 33 34 [35] 36 37 38 39 40 41 42 ... 62

Page created in 0.041 seconds with 19 queries.