Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Kev on 03 August 2006, 21:19:32

Title: Coolant pipe removal from stat
Post by: Kev on 03 August 2006, 21:19:32

Any suggestions for getting my coolant pipe out of the stat housing? X30XE.

Mine's is solid. Wiggling about slightly, but doesn't want to come out. Retaining bolt has been removed.

Title: Re: Coolant pipe removal from stat
Post by: Marks DTM Calib on 03 August 2006, 21:58:02

Get a pry bar and place it between the coolant pipe bracket and head (as close to the pipe as possible). Then apply some pressure whilst wiggling it, it should let go.....works every time for me.

Title: Re: Coolant pipe removal from stat
Post by: Kev on 03 August 2006, 22:07:31

Yup, tried that and a bit of the bracket has broken off.  :'(

Bit dubious about prying any further in case the whole bracket goes, then i'll need a whole new pipe.

I'm starting to think junior hacksaw to the old thermostat housing just at the point where it thickens up and the coolant pipe goes in. I reckon that with a little patience i'd get through ok.

I'd be able to get the pipe out and remove the remainder of the stat housing without any further damage to the bracket, wouldn't i?

It's the complete unit, stat and housing i'm replacing anyway. Er, trying to replace.

What say you?

Title: Re: Coolant pipe removal from stat
Post by: Marks DTM Calib on 03 August 2006, 22:10:33

Surprised it broke, they normaly give up and seperate, sometimes takes 5 mins of wiggling whilst applying pressure.

You could try hacksawing it.....

Title: Re: Coolant pipe removal from stat
Post by: Kev on 03 August 2006, 22:13:16

Quote

You could try hacksawing it.....

Does that sound a bit dodgy?

I initially thought it would be cos of the filings, but the stat should be shut so none should go into the block.

Should i just try wiggling again in the morning? (the light has beat me)

Title: Re: Coolant pipe removal from stat
Post by: Marks DTM Calib on 03 August 2006, 22:15:42

You need to try to get a circular motion on it.....its worth drowning it in penetraing fluid or at least some wd 40...

Title: Re: Coolant pipe removal from stat
Post by: Kev on 03 August 2006, 22:24:54

Cheers mate.  [smiley=thumbsup.gif]

I'll have another blast first thing tomorrow. I'll let you know how i go.

No doubt i'll be back here in the morning, seeking assistance, or moral support.

Title: Re: Coolant pipe removal from stat
Post by: Kev on 04 August 2006, 19:04:33

Job done!  :)

All the wigglin' in the world wasn't gonna move that pipe! Shortly after i bust my lip and tongue clean open with the pry bar i opted for the alternate method of removal, which was, thankfully a success. A few butterflies sorted the lip out.

Took plenty of pictures of the journey, minus the lip, i'll spare my blushes. Was thinking of doing a How2 if anyone is interested?

I don't see a How2 for the stat replacement, and it isn't exactly straight forward. Well, mine wasn't anyway.

Thanks anyway for your help.   [smiley=thumbsup.gif]