46
- 25 April 2024, 23:35:17
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
51
Omega Electrical and Audio Help / Re: Remote battery holder
« on: 16 May 2022, 15:39:14 »
That's how I fixed this one and it was working fine till now, so I thought there had to be something else I could do. Well, I'll repeat the procedure then. Thanks
53
Omega General Help / Re: Starting problem 3.0 v6
« on: 07 April 2022, 18:32:16 »
It's on to do list, thwnks.
Well car starts fine now, from first try
Well car starts fine now, from first try
54
Omega General Help / Re: Starting problem 3.0 v6
« on: 07 April 2022, 18:05:04 »
Nice to know it can be replaced because I found cracks on both bigger hoses inside the tank
55
Omega General Help / Re: Starting problem 3.0 v6
« on: 07 April 2022, 13:47:07 »
Well I've found rubber outlet line on the top of the pump spinning almost freely, which could allow fuel to escape back from the pressured fuel lines.
I took omega for a drive after retightening the rubber hose and now I'll wait for an hour to see if it starts. Will report
I took omega for a drive after retightening the rubber hose and now I'll wait for an hour to see if it starts. Will report
56
Omega General Help / Re: Starting problem 3.0 v6
« on: 06 April 2022, 19:05:03 »
I already had the pump out, when working on it, because there was old fuel in tank, I should have taken a number of it then. I'll check all the rubber lines tomorrow, It's not that difficult.
Thanks
Thanks
57
Omega General Help / Re: Starting problem 3.0 v6
« on: 06 April 2022, 18:58:07 »
Ok, then pump will get replaced...thanks
58
Omega General Help / Re: Starting problem 3.0 v6
« on: 06 April 2022, 18:47:37 »
I replaced fuel pressure regulator and it still does the same thing. It seems it's loosing fuel pressure somewhere as there is no fuel loss, when I unscrew 17 and 19 mm fuel lines that go under plenum
60
Omega General Help / Re: Starting problem 3.0 v6
« on: 27 March 2022, 10:47:00 »
That seems logical, thanks. A I don't have pressure gauge I might as well buy a new pressure regulator.
Does anyone have part number for it?
I assume it's plenum off job, am I right?
Thanks in advance
Does anyone have part number for it?
I assume it's plenum off job, am I right?
Thanks in advance