Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: robson on 04 November 2018, 08:38:01
-
where can I get rear brake pad pins for my 03 2.6 saloon vented disc.They appear to be difficult to find. Anybody know the pin length to save be taking the wheel off.
-
I’ve seen Unicorn Poo more recently than a new Vented Rear fitting kit :-X ::) :D
-
Do they need replacing? Its rare the pins fail/wear....
-
I wanted a set incase I found a problem whilst fitting new pads.Have done the job one pin was slightly corroded and the other ok.The length for future reference is 85mm.Eurocrap do a kit for vented disc but they are too short.
-
Main dealer or US...
Exact component dimensions are given here, clearly visible on the forum menu under Omega FAQs :y
-
just looked at faq the pin dimension was 75mm I think that is what I was offered for my car with vented discs My pins are 85mm overall.
-
Main dealer or US...
Exact component dimensions are given here, clearly visible on the forum menu under Omega FAQs :y
You mean this?
http://www.omegaowners.com/forum/index.php?topic=127928.0
-
Exactly :y
-
sorry didn't pay attention to drawing. :y
-
sorry didn't pay attention to drawing. :y
I would have used words, but they tend to get misconstrued ::)
-
sorry didn't pay attention to drawing. :y
Picture paints a thousand words. ;)
-
It's the springs that fail. the central rivets rust through. Perhaps I should keep some spares.
-
In hand brake shoes, yes??
-
In hand brake shoes, yes??
Terry means the anti rattle springs for the rear pads, but yes the hand brake shoe retainers also rot away with backing plate ;)
-
OK, sorry, good to know what we are talking about, thanks!