Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: DrAndyB on 10 February 2018, 18:40:09
-
I have acquired a DAB Transmitter, and instructions suggest sticking small DAB aerial to side of screen by the A Pillar, but I need to remove the trim to stick / ground one bit to the metal.
How easy does the Trim come off and go back ?
Thanks in advance.
Andy.
-
Fairly easy, though its a large piece from memory.
Again, from memory, undo 2 screws and remove grab handle, then it pulls off, needing slight deforming to remove from B pillar.
Make sure all metal tabs/clips are in right place and not deformed before refitting.
-
Your memery is 100% correct. Just taken mine off yesterday ! To check for a minor water leak at the screen corner.(i think)
-
Thanks all.
I guess the Grab handle holds the top place in position then - Didn't think it went that far up to handle on roof, but I've never really looked or removed one :D.
I'll explore tomorrow :y
I may want to "Pop" the little cubby hole / tray out to the left of the radio. Is this simple to remove as well ? ??? (Mini Facelift model)
-
You can also undo the screw at the top of the best pillar to ease the removal/refit of the front trim... T25 torx hidden behind the alarm interior sensor/blanking plate.
Upon removal of the a pillar trim, retrieve the metal clips and refit them to the trim :y
-
:y Thanks all for help. :y
-
Didn't think it went that far up to handle on roof, but I've never really looked or removed one :D.
Although it looks like 2 pieces, the A pillar trim and the trim between A and B pillars is actually one piece.
-
I may want to "Pop" the little cubby hole / tray out to the left of the radio. Is this simple to remove as well ? ??? (Mini Facelift model)
It just pops out, though you may have to remove radio & cage to give it a nudge from behind.