Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 2 [3]  All   Go Down

Author Topic: Reaching plugs and leads on NS bank  (Read 3530 times)

0 Members and 1 Guest are viewing this topic.

05omegav6

  • Guest
Re: Reaching plugs and leads on NS bank
« Reply #30 on: 29 October 2014, 13:31:15 »
Undo the vac pipe, unplug the rear multiram, then remove the two bolts from the cable tray. Lift the tray up and inboard so that it kind of sits on the vac outlet. Remove oil filler tube and temporarily fit the cap to the camcover. Coilpack should then lift out :y

Drivers side has enough space to roll the coil pack out beneath the fuel lines, so no need to disturb them or the plenum :y

Passenger side takes 15 mins or so, and drivers side takes about 5 mins :y
Logged

terry paget

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Midsomer Norton Somerset
  • Posts: 4633
    • 3 Astras 2 Vectra
    • View Profile
Re: Reaching plugs and leads on NS bank
« Reply #31 on: 29 October 2014, 17:43:53 »
Brilliant. Thanks, Al. Your reply came too late for today's job, I was almost there, but had not removed the plenum dual ram plug. I shall know next time.
Logged

05omegav6

  • Guest
Re: Reaching plugs and leads on NS bank
« Reply #32 on: 29 October 2014, 18:19:19 »
 :y
Logged
Pages: 1 2 [3]  All   Go Up
« previous next »
 

Page created in 0.024 seconds with 22 queries.