Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Cylinder Heads

« on: 21 June 2018, 13:19:42 »

Hi Guys,

Can anyone tell me are the heads in a 2.5 the same as the 3.2?

If not are the camshafts interchangeable?

Thanks in anticipation

2

Omega General Help / P1890 fault code

« on: 20 June 2018, 15:41:16 »

Hi guys anyone got a fix for fault code P1890?

3

Omega General Help / Re: Cam shaft pulleys

« on: 04 June 2018, 17:41:51 »

the pulleys are on the right cams but can they be rotated through 180 degrees? causing a timing problem

4

Omega General Help / Cam shaft pulleys

« on: 03 June 2018, 09:51:45 »

is it possible to put the camshaft pulleys on upside down because of the keyways?
If it is how can tell which is the right way (ps they were not marked when taken off)?
Is the y32se  engine a safe engine?

5

Omega General Help / Re: Radiator Question

« on: 19 November 2016, 21:27:19 »

Hi Squatch the radiator is the same for automatics and manuals, not too hard a job to do either

6

Omega General Help / Re: Speedo, gauges not working and warning lights on

« on: 19 November 2016, 14:14:39 »

Just had multimeter on the battery and the voltage is going down by 0.01 volts every 5 secs or so

7

Omega General Help / Re: Speedo, gauges not working and warning lights on

« on: 19 November 2016, 12:54:02 »

cant see anything obvious, do i need to remove the dash ? battery drained overnight, is it possibly something else, please help I am at the end of my tether with this car

8

Omega General Help / Re: Radiator leak

« on: 11 November 2016, 16:18:08 »

Hi Charlieboy,

I have changed several Omega radiators over the years, around £100 from local motor factors (so any problems easy to return) and the job is easy enough about an hour to an hour and a halfs work.

9

Omega General Help / Re: Speedo, gauges not working and warning lights on

« on: 11 November 2016, 16:10:34 »

Thanks guys, removed power sounder (Did not go off), do not know if it should or not. started car did same so will delve deeper tomorrow. Is the dash fuse box the best place to start?

10

Omega General Help / accelerator Problem

« on: 08 November 2016, 19:55:19 »

Please can someone help please,

When I press the accelrator all gauges stop working and engine management, abs , tc and air bag lights come on. let car go back to idle gauges work again lights go out. This happens while driving or sat still. Really stuck with this one.

11

Omega General Help / Re: Speedo, gauges not working and warning lights on

« on: 07 November 2016, 15:58:29 »

More inclined to think it is abs ecu problems

12

Omega General Help / Speedo, gauges not working and warning lights on

« on: 07 November 2016, 12:58:57 »

Hi Guys,

My MV6 is playing up, when I press the accelerator the speedo , rev counter and fuel gauge all stop working, the abs and traction control lights come on, occasionally the airbag warning light too. when i release the accelerator the lights go out and the gauges start working again. Any ideas where to start please

13

Omega General Help / Re: Non Starting 3,2 Omega

« on: 11 October 2016, 18:52:04 »

Yeah have done, found more horrors, oil in the spark plug wells, time to check breathers and replace cam cover gaskets.

14

Omega General Help / Re: Non Starting 3,2 Omega

« on: 10 October 2016, 18:27:12 »

Yes it is a 3.2 irmscher mv6, it has a code stating mis-fire cylinder 4, it has a irmscher stainless exhaust

15

Omega General Help / Re: Non Starting 3,2 Omega

« on: 10 October 2016, 16:00:03 »

Thanks for all your help, it was just the starter motor , fixed now, what a pain that job is.

Got to fix the other one now as it just failed its MOT 2 x front brake pipes easy job, but it has also failed on emmisions, any ideas guys? PLEASE