Omega Help Area > Omega General Help
4 Wheel Alignment settings needed
Andy A:
I am just about to book the Omega 2.2i 2003 in for a 4 wheel alignment and would like to take the correct setting with me so I can double check they are correct. I was going to have it done a while back but never got around to it. I have never had one done before.
Has any one got the list or printout of all the correct settings please?
Thanks
Doctor Gollum:
Rear Toe and Camber will be a compromise, but Thrust angle MUST be zero.
Front, Toe is +0°03"
Camber should be - 1°10"
No ifs or buts :y
If they claim that they can't then achieve these settings take it somewhere that can/will. :y
Andy A:
--- Quote from: Doctor Gollum on 28 April 2019, 20:03:01 ---Rear Toe and Camber will be a compromise, but Thrust angle MUST be zero.
Front, Toe is +0°03"
Camber should be - 1°10"
No ifs or buts :y
If they claim that they can't then achieve these settings take it somewhere that can/will. :y
--- End quote ---
What are the rear settings or are they identical to the front?
Doctor Gollum:
The rear settings vary car to car as they have a single adjustment that does both camber and track. But it is fundamentally critical that the thrust angle is zero :y
Andy A:
--- Quote from: Doctor Gollum on 29 April 2019, 12:44:14 ---The rear settings vary car to car as they have a single adjustment that does both camber and track. But it is fundamentally critical that the thrust angle is zero :y
--- End quote ---
Thanks Al. :y :y
Navigation
[0] Message Index
[#] Next page
Go to full version