Omega 3.0 elite estate 1997 car was not starting , well would with a lot of effort, so i odb2 came up low voltage MAF, so i purchased a new MAF fitted. cleared error codes runs ok. the problem i have before the problem MAF i could turn the key no throttle startup no problem, no i need to apply a little throttle to start, also if engine idling, and i depress the throttle quickly ,, there is a slight delay before pick like dead spot
if i depress normally seems ok, i have ordered a new air filter to see if its that. i have been told it takes 20 miles for the ecu to setup after MAF fitting .... is that True?
Also looking at the back of the engine top under scuttle there is a Rubber Hose about an inch across not connected no clip on it can not see where it goes looks like it goes down to the sump could it be a breather, please advise