Omega Help Area > Omega General Help

Auto Shift Lever not lining up.

(1/2) > >>

Duke01:
Afternoon, I had both engine mounts done recently, ever since then, the shift lever doesn't seem to correctly line up with the gears but was fine before.
It also slips out of park when facing uphill....
Any ideas?

Bigron:
Lift the engine off its mounts a little, then re-settle it again?

Ron.

Shackeng:
I would certainly be taking it back to whoever did it. :y

Doctor Gollum:
No reason to disturb the gear linkages to change the engine mounts ???

By that I mean they can be done on the ground using little more than a trolley jack, block of wood, and a short, offset 16mm ring spanner...

Nick W:

--- Quote from: Doctor Gollum on 15 April 2018, 19:58:58 ---No reason to disturb the gear linkages to change the engine mounts ???

By that I mean they can be done on the ground using little more than a trolley jack, block of wood, and a short, offset 16mm ring spanner...

--- End quote ---


perhaps the engine was jacked too high and has bent the shift linkage?


Actually, I can't see how else the problem could have been caused.

Navigation

[0] Message Index

[#] Next page