Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Calliper Hole Spacing.  (Read 1381 times)

0 Members and 1 Guest are viewing this topic.

Davey

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Berkshire
  • Posts: 103
    • View Profile
Calliper Hole Spacing.
« on: 03 August 2006, 08:54:08 »
I was looking round a friend of the families lockup last night and came across a brand new set of Mercedes 4 pots and 330mm discs, the PCD for the merc is almost the same as the omega (5x112), just wondering if anyone knows the bolt hole spacing on the calliper mounting brackets i.e. the distance between the centre of the two holes, I don't have an omega calliper to hand so can not compare. However the merc item has 100mm spacing.

Cheers!

Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 33832
  • Git!
    • View Profile
Re: Calliper Hole Spacing.
« Reply #1 on: 03 August 2006, 09:04:15 »
I dont know the spacing but, there is a reasonable chance they will fit as Mercedes use the same brake setup supplier....
Logged

Davey

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Berkshire
  • Posts: 103
    • View Profile
Re: Calliper Hole Spacing.
« Reply #2 on: 03 August 2006, 09:08:25 »
Bonus!

I need some decent anchors for the new engine and these seem to be a promising solution, plus they'll look standard in the black powder coat ;)
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.024 seconds with 21 queries.