Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Wanted: Ignition barrel  (Read 1335 times)

0 Members and 1 Guest are viewing this topic.

Shackeng

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Ramsbury
  • Posts: 7762
    • 3.2 Elite 2.0 TitX Mondeo
    • View Profile
Wanted: Ignition barrel
« on: 16 December 2016, 16:06:49 »

As above, I guess they are all the same. This is for my TD. :y
Logged

Diamond Black Geezer

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • N E Lincolnshire & Warwickshire
  • Posts: 5694
  • Diamond Black '96 CDX V6 - 'Pissy'
    • & a silly coupe coming...
    • View Profile
Re: Wanted: Ignition barrel
« Reply #1 on: 16 December 2016, 16:25:02 »

Might be able to get you a cheap one tomorrow morn? (off to see a scrapper, might be able to grab you it for beer money off the bloke)

Of course the 'rebuild it with new sliders' option is there, too.


If you fear getting stuck unable to turn the key in the middle of nowhere, then in the short term, remove some of the troublesome sliders, a car thief can't exactly tell from the outside that you've done it.  :)
Logged
Ex-Dealer Kent-Moore Rear Wheel Bearing Tool available for hire, PM for details.

"There's no point in being grown up if you can't be childish sometimes." 4th Doctor

Shackeng

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Ramsbury
  • Posts: 7762
    • 3.2 Elite 2.0 TitX Mondeo
    • View Profile
Re: Wanted: Ignition barrel
« Reply #2 on: 16 December 2016, 16:43:29 »

Might be able to get you a cheap one tomorrow morn? (off to see a scrapper, might be able to grab you it for beer money off the bloke)

Of course the 'rebuild it with new sliders' option is there, too.


If you fear getting stuck unable to turn the key in the middle of nowhere, then in the short term, remove some of the troublesome sliders, a car thief can't exactly tell from the outside that you've done it.  :)

Cheers DBG, no problem with the sliders as they were replaced not long ago, and will be refitted to a replacement barrel. The retaining latch on mine is broken, and it is held in by a very small roll pin in a blind hole, so probably not replaceable, and in any case would have to come off another barrel.
Someone may have one in their 'parts store', if not I'll let you know. Thanks very much. :y
Logged

Doctor Gollum

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • In a colds and darks puddleses
  • Posts: 28190
  • If you can't eat them, join them...
    • Feetses.
    • View Profile
Re: Wanted: Ignition barrel
« Reply #3 on: 16 December 2016, 17:13:57 »

Pauls might have one... Sure there was one in the ecu etc he had of me a while back :-\
Logged
Onanists always think outside the box.

Shackeng

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Ramsbury
  • Posts: 7762
    • 3.2 Elite 2.0 TitX Mondeo
    • View Profile
Re: Wanted: Ignition barrel
« Reply #4 on: 16 December 2016, 17:15:47 »

Pauls might have one... Sure there was one in the ecu etc he had of me a while back :-\

 :y :y :y
Logged
Pages: [1]   Go Up
 

Page created in 0.038 seconds with 18 queries.