Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1] 2  All   Go Down

Author Topic: Fault Code 2106  (Read 306 times)

0 Members and 1 Guest are viewing this topic.

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Fault Code 2106
« on: 02 November 2017, 16:20:44 »

Ive the Following Codes, spanner light on.
0650
2106
1612

3.2, been stood for a while, new battery, fired up first time, no issues, then after a min or 2 starts to stutter, initial thoughts was missfire, restarted, fine then stutter again, go to pull away drops revs, almost like fuel starvation.

Peddle tricked for codes, I think the 0650 may be one of the bulbs is out (airbag?), googled code 2106, comming back as generic, Throttle / Peddle Sender? Is this the case for Omega?

Car now wont start, it does but ticks over low then stalls, any effort on the throttle stalls striaght away. Going to consetrate on this fault first but where to start???, help pleasd.

Code 1612 could be a red herring as batt now low (no flashing Spanner).
Logged

TheBoy

  • Administrator
  • *********
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 94510
  • Ah, the Silver Bullet
    • Jaaaaaaaag
    • View Profile
Re: Fault Code 2106
« Reply #1 on: 02 November 2017, 18:08:05 »

Not received a status update from TCM for over 10s
Logged
I don't tolerate bickering, and I'm always grumpy.
And Lizzie Zoom says I'm a heartless bastid...and she's absolutely correct!

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #2 on: 02 November 2017, 18:38:52 »

Not received a status update from TCM for over 10s
Ok thanks, so what to look for?, plugs / connectors around peddle and TB's, anything else, any part testing I can do?

Anyone had this before, and what was the outcome?

Ta.
Logged

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #3 on: 02 November 2017, 18:40:37 »

Would it be worth swapping over the TB's for a known good one, 3.2 and 2.6 are they the same?
Logged

TheBoy

  • Administrator
  • *********
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 94510
  • Ah, the Silver Bullet
    • Jaaaaaaaag
    • View Profile
Re: Fault Code 2106
« Reply #4 on: 02 November 2017, 18:42:24 »

Would it be worth swapping over the TB's for a known good one, 3.2 and 2.6 are they the same?
Nothing to do with TB. Its TCM. Is it an auto?
Logged
I don't tolerate bickering, and I'm always grumpy.
And Lizzie Zoom says I'm a heartless bastid...and she's absolutely correct!

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #5 on: 02 November 2017, 18:43:21 »

Would it be worth swapping over the TB's for a known good one, 3.2 and 2.6 are they the same?
Nothing to do with TB. Its TCM. Is it an auto?
No 3.2 Manual,
Logged

TheBoy

  • Administrator
  • *********
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 94510
  • Ah, the Silver Bullet
    • Jaaaaaaaag
    • View Profile
Re: Fault Code 2106
« Reply #6 on: 02 November 2017, 18:46:29 »

Would it be worth swapping over the TB's for a known good one, 3.2 and 2.6 are they the same?
Nothing to do with TB. Its TCM. Is it an auto?
No 3.2 Manual,
Well that's your problem. Find a local Tech2, and set ECU config back to manual :)
Logged
I don't tolerate bickering, and I'm always grumpy.
And Lizzie Zoom says I'm a heartless bastid...and she's absolutely correct!

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #7 on: 02 November 2017, 18:46:50 »

Would it be worth swapping over the TB's for a known good one, 3.2 and 2.6 are they the same?
Nothing to do with TB. Its TCM. Is it an auto?
No 3.2 Manual,
But.... Im trying think,....  did I I borrow the ECU same time back to prove an ECU issue on an Auto? and not put it back, either way it was running fine untill today  :-\.
Logged

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #8 on: 02 November 2017, 18:49:38 »

Would it be worth swapping over the TB's for a known good one, 3.2 and 2.6 are they the same?
Nothing to do with TB. Its TCM. Is it an auto?
No 3.2 Manual,
Well that's your problem. Find a local Tech2, and set ECU config back to manual :)
I take it you mean Engine ECU, if so thought they were Auto / Manual from a High / Low (Loom) pin on the ECU
Logged

TheBoy

  • Administrator
  • *********
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 94510
  • Ah, the Silver Bullet
    • Jaaaaaaaag
    • View Profile
Re: Fault Code 2106
« Reply #9 on: 02 November 2017, 19:11:29 »

Would it be worth swapping over the TB's for a known good one, 3.2 and 2.6 are they the same?
Nothing to do with TB. Its TCM. Is it an auto?
No 3.2 Manual,
Well that's your problem. Find a local Tech2, and set ECU config back to manual :)
I take it you mean Engine ECU, if so thought they were Auto / Manual from a High / Low (Loom) pin on the ECU
Yes, Engine ECU, ie ECM.

Not sure that's the case on the CAN ones. I'd bow to your expertise on that one TBH, regarding the loom mod.

But U2106 is basically it hasn't spoken to the TCM for a few seconds (and presumably it was expecting to).
Logged
I don't tolerate bickering, and I'm always grumpy.
And Lizzie Zoom says I'm a heartless bastid...and she's absolutely correct!

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #10 on: 02 November 2017, 19:23:26 »

So, if I borrow ECU (Ring & Trans' Chip) from another Manual that should prove the fault ?

Edit:, actually not too sure about the Loom High Low thing on the 3.2, I know it was the case on the 2.5 and 3.0, so yea, maybe a ECO config, problem is I seem to have gone brain dead today, memory's been erased  :-[ 
« Last Edit: 02 November 2017, 19:28:13 by zirk »
Logged

TheBoy

  • Administrator
  • *********
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 94510
  • Ah, the Silver Bullet
    • Jaaaaaaaag
    • View Profile
Re: Fault Code 2106
« Reply #11 on: 02 November 2017, 19:37:00 »

yup, ecu swap should prove that
Logged
I don't tolerate bickering, and I'm always grumpy.
And Lizzie Zoom says I'm a heartless bastid...and she's absolutely correct!

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #12 on: 02 November 2017, 20:08:28 »

yup, ecu swap should prove that
Ok, Thanks TB, job for tomorrow then as other Car is about 20 miles away.  ::)

I'll post up the results
Logged

serek

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • huntingdon
  • Posts: 1961
    • 3.2 mv6
    • View Profile
Re: Fault Code 2106
« Reply #13 on: 02 November 2017, 20:28:01 »

I know sound odd but try disconnect maf sensor
I had 4 or 5 omega 3.2 with same issue
Car start and tick over but won't rev

zirk

  • Omega Queen
  • ********
  • Offline Offline
  • Gender: Male
  • Epping Forest
  • Posts: 10240
  • 3.2 Manual Special Saloon ReMapped and LPG'd and
    • 3.2 Manual Special Estate
    • View Profile
Re: Fault Code 2106
« Reply #14 on: 02 November 2017, 20:47:28 »

I know sound odd but try disconnect maf sensor
I had 4 or 5 omega 3.2 with same issue
Car start and tick over but won't rev
Will try that Serek before swapping ECU's

Dziękuję

Logged
Pages: [1] 2  All   Go Up
 

Page created in 0.11 seconds with 16 queries.