Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Pages: [1]   Go Down

Author Topic: headlight position  (Read 1018 times)

0 Members and 1 Guest are viewing this topic.

raywilb

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • york
  • Posts: 1868
    • DS DS4
    • View Profile
headlight position
« on: 10 November 2017, 20:08:19 »
after a prang & having put on a bumper the plastic trim underneath the doesn't fit .  I have noticed the headlight seems to be to far in on the side that's next to the grill, when I measure with a steel rule from a point on the washers to the lens there is a 20mm + difference to the other h/l. I got the reinforcing with the brackets attached so that's ok. so I guess the H/L needs to come forward a tad with the lens tilted forward. just how I'm not sure.
Logged

Doctor Gollum

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • In a colds and darks puddleses
  • Posts: 28172
  • If you can't eat them, join them...
    • Feetses.
    • View Profile
Re: headlight position
« Reply #1 on: 10 November 2017, 20:48:59 »
By pulling the slam panel assembly back into alignment  ::)
Logged
Onanists always think outside the box.

raywilb

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • york
  • Posts: 1868
    • DS DS4
    • View Profile
Re: headlight position
« Reply #2 on: 10 November 2017, 21:20:46 »
Quote from: Doctor Gollum on 10 November 2017, 20:48:59
By pulling the slam panel assembly back into alignment  ::)
  do you mean the bar behind the bumper , if you do all the pushfit rivet holes met up as they should including those 3 underneath. when the bonnet is shut at the wing side its ok but at the bonnet side the lens seems to dip in & ends up behind the line of the bonnet
Logged

Doctor Gollum

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • In a colds and darks puddleses
  • Posts: 28172
  • If you can't eat them, join them...
    • Feetses.
    • View Profile
Re: headlight position
« Reply #3 on: 10 November 2017, 21:39:14 »
No, I mean the slam panel...

You will find that the vertical portion adjacent to the radiator is creased where it is welded onto the inboard edge of the chassis rail...

About 2" down from where the inner edge of the headlight rests against it
« Last Edit: 10 November 2017, 21:43:48 by Doctor Gollum »
Logged
Onanists always think outside the box.
Pages: [1]   Go Up
« previous next »
 

Page created in 0.038 seconds with 19 queries.