Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 [2]  All   Go Down

Author Topic: Fitting poly bushes to front wishbones  (Read 2943 times)

0 Members and 1 Guest are viewing this topic.

YZ250

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Oxford/Bucks border
  • Posts: 4172
    • Black 3.2 Elite Estate
    • View Profile
Re: Fitting poly bushes to front wishbones
« Reply #15 on: 18 January 2018, 20:15:58 »
Quote from: Fuse 19 on 18 January 2018, 10:18:39
Yes, I have done this on a few if the other components are all ok.

Its a case of removing the front bolt and then wedging the wishbone such that the front bush is visible below the sub frame.
..........

Yep, as above. I wedged a bit of timber in there to keep the bush clear of the fixing point. Wasn't a bad job, considering I did it on the drive.  :y

Logged
My fun car is a 2020 Bmw F32 430d M Sport with indicators.
My cruiser is an Audi A6 Avant S Line Black Edition with indicators.
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.041 seconds with 18 queries.