7666
Meetings, gatherings, parties etc / Re: Cam Belt Meet - NE Hampshire
« on: 25 February 2011, 09:03:06 »Quote
QuoteChrisgixer. dif and ATF change.
Entwood ... ATF change & Tech2 check of gearbox software
Lazydocker... Oil and filter change, fuel filter, clean ICV, repair wiring to Outside Temp Sensor and (most importantly!) sort sticking handbrake.
TheBoy... CamCover gaskets (MV6)
Sethsmate ... Tech2 chat
Jack86... ATF change and oil and filter, glove box handle and fitting my HID's.
Twiglet... ATF and Diff oil change, move pre-cat lamdas, resolve mis-fire issue (coil-packs/cam cover gaskets), Tech2 chat.
Taxi Al... Cambelt, waterpump, breathers, cruise activation. general service bits if time
aaronjb... Camcover gasket on pass. side & tech2 w/ g/box check/upgrade pretty please
Kieran .... Cam cover gaskets 2.6, Thermostat housing seal also
Shakeng.... Front/rear bush check(may as well do the rears?)
Kevin Wood... Dif seal, Relocate Lambda sensors / try "anti-fouler" solution.
Gives
ATF change x4
dif related x3
Lambda related x2.
Cam cover seals x3
Cam belt/water pump x1(only 1?)
Stat housing x1
Handbrake x1
and a bunch of easy service stuff
Tech2 for most I guess? Guess there will be two present?
So, we have one lift and two pits as I understand it? I reckon they should cover the dif ATF and lambda jobs in a day. ATF should be doable in an hour with proper access and pumpy thing.( two gaskets, ATF and clean the filter). The rest there should be time for in other bays at ground level....? ESP with a Daz bombing round the place.
No suspension stuff so far.
Where's best place to get ATF sumps gaskets?
I've only just seen this post, and stealer is unable to get rear bushes until Tuesday, so scratch that off the list. Sorree!