Omega Help Area > Omega Electrical and Audio Help

Wiper stalk problem

(1/5) > >>

Jan Suhr:
Well I'm kind of stuck here.

My "new" winter car was fitted with the NCDC 2013 head unit and the NAV-display. It seems that when fitted with this the wiper stalk is a bit simpler with no buttons to change the display messages.

I have removed the NCDC 2013 unit to be replaced more modern stuff and also put in the simpler display. The display itself seems to work alright but with the original wiper stalk I can't change any messages on the display.

From my old Omega that I scrapped I got the wiper stalk with buttons (Got the display from that one too) but that one has an extra connector with 5 wires going to it. But the car doesn't obviously have the connector to the wiper stalks extra connector. I also suspect that the wiper interval control are in some of those five wires.

I guess that the display controls are on the NCDC 2013 unit and then there must be some wires there that I could hook up my new wiper stalk to.

Is this possible??


The original to the left and the one to the right I want to put in.





Thanks

TheBoy:
you need to run 2 wires from stalk to display, and 1 wire from stalk to one of the ground/earth studs behind instrument panel

Jan Suhr:

--- Quote from: TheBoy on 17 October 2018, 20:06:13 ---you need to run 2 wires from stalk to display, and 1 wire from stalk to one of the ground/earth studs behind instrument panel

--- End quote ---

Thanks, can you be more specific on which ones. The brown is ground but which two to the display. There must be some wires already hooked up for this to the display that comes from the head unit.

TheBoy:
Do you have a wiring diagram, eg Haynes book of 'dangle berries', as I'm not near mine.

Jan Suhr:
I have a good contact at the local GM service station. He has provided me with diagrams before. I'll try to check with him.

I do have the Haynes manual but the one I have is for 94-99 pre-Face lift Omegas.


Thanks

Navigation

[0] Message Index

[#] Next page