Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Big_Al on 15 September 2006, 23:26:54

Title: No heater after after HBV change
Post by: Big_Al on 15 September 2006, 23:26:54
Hi Guys, can anybody help on this one . just changed HBV & flushed out cooling system as my 3.0 was running a bit warm  ( around 100 mark) This has cured that problem & gauge now sits steady at 95. But cant get heater to blow hot . Cold & air con are fine. Both pipes at bulkhead to heater matrix in engine bay  are hot but no heat inside car . HELP !   cheers, Big Al
Title: Re: No heater after after HBV change
Post by: Admin on 16 September 2006, 00:07:45
I recommend checking all your vacuum connections Al. The heater system is vacuum controlled so that is most likely where the problem is. :)
Title: Re: No heater after after HBV change
Post by: TheBoy on 16 September 2006, 08:53:56
You may have a small airlock causing a problem as well.  But vacuums, as suggested, are most likely...
Title: Re: No heater after after HBV change
Post by: Big_Al on 18 September 2006, 07:26:15
Thanks , I will check out the the vac connections.