Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Jim]

Can anyone help my passenger electric seat has stuck in the full extended rear position, the height and tilt still work it's the back and forward that don't, can it be moved manually,I've checked all the connection's

[tunnie]

Can anyone help my passenger electric seat has stuck in the full extended rear position, the height and tilt still work it's the back and forward that don't, can it be moved manually,I've checked all the connection's

Could have gone to far and got stuck, you should have a bar in the boot kit which has a square tip.

You can stick it in the back of the motor one closest the gearbox and rotate it, it will very slowly move the seat forward.

Also if you can strip down the button assembley, check the actual switch is making a good connection

[Hillper]

It may start to work when you wind it forward a bit.

Otherwise, it's a case of checking for voltage on the connectors, and motor terminals.

If was mine, I would suspect 'Werther blockage' in the runner.

[Jim]

Cheers Guys, I'II give it a go in the morning and report back

[Liam]

Mine did this once.  Sitting on the seat wiggling whilst massaging the buttons soon sorted it out.

Liam

[Hillper]

   And how did you fix the seat?

[Kev]

Hope it works or that'll be another on my 'Jobs Pending' list.  

[Jim]

Hope it works or that'll be another on my 'Jobs Pending' list.  

Aye

[Agemo]

WOAH!!! What bar??? I don't have one, any chance of a pic? Please!
 

[tunnie]

WOAH!!! What bar??? I don't have one, any chance of a pic? Please!
 

Err mines in the 3.0 and its dark outside  

I can get a piccy tomorrow, its a thin bar with the jack kit.... it looks like an allen key ish... hard to decribe.

I'll get a piccy for you tommorow...  [smiley=thumbsup.gif]

[Agemo]

Thanks Tunnie, I would appreciate that, no rush. I must have one, it can go with the rest of the "must haves" that I never have used. (fuse puller, wheel stud remover, radio removal tool, dust cap tool from a Vectra)
 

[TheBoy]

Its a small crank handle, about 4" long, though I'm sure Tunnie will have a piccie soon (ie, when the lazy git gets up )

[tunnie]

Its a small crank handle, about 4" long, though I'm sure Tunnie will have a piccie soon (ie, when the lazy git gets up )

Ha! Look see 10.35. Reasonable time!   - Piccy will be up soon

[tunnie]

What you need is this:



Looking at the seat (ie looking towards the back of the car) insert the sqaure end of the bar into the motor on the right hand side.

Turn it clockwise to bring the seat forward, and anti-clock to push it back. It will move very very slowly, takes about 50 turns to bring it about an inch! But fix on one point of the seat and you will see it slowly moving...

[Taxi_Driver]

Carpet could do with a bit of a vacuum Tunnie