Topic: wiring route for O2 sensors (Read 561 times)

Andy B · « **on:** 25 February 2013, 21:11:26 »

I was under my car today at a fast fit centre to see if I/we

could locate where it's blowing slightly from (nearside manifold to downpipe looks a likely candidate) which ties in with when I had the rear crank seal replaced .... they'll have had to drop the front pipes to drop the gearbox.
While under the car, I could see the wiring for both O2 sensors dangling in the breeze, each tie wrapped to it own clip that the previous garage had obviously forgotten to replace. Due to fast fit fitter being in the way I couldn't see where they should fasten to.

Anyone? $:-\$

Andy B · « **Reply #1 on:** 25 February 2013, 22:01:18 »

Doesn't look like anyone has recently replaced a down pipe or lambda then

YZ250 · « **Reply #2 on:** 25 February 2013, 22:03:16 »

Picture not that clear but they appear to clip on exhaust brackets. $:-\$

Andy B · « **Reply #3 on:** 25 February 2013, 22:06:06 »

Quote from: YZ250 on 25 February 2013, 22:03:16

Picture not that clear but they appear to clip on exhaust brackets. $:-\$

....

Cheers Alan, I'll see what i can see if I get around to doing something with the exhaust leak

News:

Author Topic: wiring route for O2 sensors (Read 561 times)

Andy B

wiring route for O2 sensors

Andy B

Re: wiring route for O2 sensors

YZ250

Re: wiring route for O2 sensors

Andy B

Re: wiring route for O2 sensors