Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: y26se starter removal

« on: 15 February 2019, 08:18:52 »

hi guys meant to point out have removed one bolt and engine mount to find the bottom bracket doesnt match the pics on v6 starter removal ie doesnt have the four bolts holding it in place looks like one bolt in middle but appears to be part of body inner?have also jacked sump as in pics to clear bracket.thank for your replies

2

Omega General Help / y26se starter removal

« on: 11 February 2019, 15:02:06 »

anyone had any issues with starter change y26se 2.6cdx 02 plate.engine mount differs from the one in the pics.the one i have has only one bolt in bottom.also looks like its part of the body?! and cant be removed?anybody come across this before? thanx in advance.

3

Omega General Help / y26se starter removal

« on: 11 February 2019, 14:20:07 »

hi everyone.anyone had a different engine mount next to starter? this is a 2.6cdx with a different engine mount from the one in the pics of y26se starter removal doesnt have four bolts but only one under the mount.also doesnt seem that you can remove it?looks like part of body!thanks in advance.

4

Omega General Help / Re: STARTER PROBLEM

« on: 12 December 2018, 15:51:11 »

its a manual sorry.would i be ok to try with a few bodies pushing?

5

Omega General Help / Re: STARTER PROBLEM

« on: 12 December 2018, 15:36:20 »

sorry guys.meant bump start have already tried 2 sets of jump leads on 2 different cars.stuck at work at moment.full beam + fans work ok just clicks when key turned.can i attempt a bump start to maybe get me home?.thanks.

6

Omega General Help / STARTER PROBLEM

« on: 12 December 2018, 14:04:16 »

hi everyone quick question can i jump start car y26se cdx with faulty starter ie just clicking not turning over.battery charged ok.thanks

7

Omega General Help / Re: battery problem?

« on: 14 November 2018, 08:14:47 »

thanx guys.much appreciated.will check all those.thanx again.

8

Omega General Help / Re: battery problem?

« on: 13 November 2018, 10:46:01 »

hi keith,is that starter,battery internal or battery to body or alternator to battery etc etc.could you please be a little more specific thanx in advance.

9

Omega General Help / battery problem?

« on: 13 November 2018, 08:39:02 »

y26se 2.6cdx  just a quickie(hopefully) when turning engine over after journey of 20 miles or so sounds like flat battery!.on short journeys ie 10 miles or so is fine every time?.charged battery run over 30 miles still same?. on the last drop of juice started.left it half a day and plenty of juice to start engine.is this battery? surely not stsarter or something bit more serious? thanx in advance.

10

Omega General Help / Re: y26se headlights removal

« on: 05 October 2018, 14:00:18 »

thanks for your time doc.will persevere.let you know the outcome.

11

Omega General Help / Re: y26se headlights removal

« on: 05 October 2018, 12:14:24 »

the plastic trim under the headlight hooks in.then theres a piece of rubber around the light but no screwhole behind it on bottom nor has there ever been one by the look of it.this is the same on passenger side and drivers side.it was ex plod but i dont think this may have made any difference?.there was a plastic pin at side as well. it levers out but is still fastened behind curv where indicator is?!

12

Omega General Help / Re: y26se headlights removal

« on: 05 October 2018, 10:38:16 »

hi doc gollum as explained in thread doesnt have the bottom nut as explained in guide. seems to be behind the curved part behind indicator and its on both sides of vehicle.have to remove battery + air filter on both sides but cant see bolt?! although its definitely attached there.

13

Omega General Help / y26se headlights removal

« on: 05 October 2018, 08:34:07 »

hi guys,wonder if anyone has removed a headlight unit from y26se before.it is unlike the cx25xe there is no bottom nut?! but there is something holding it at the back of the indicator part.buggered if i can see it.anyone any ideas?.thanks in advance.

14

Omega General Help / Re: coolant level switch

« on: 09 May 2018, 08:25:45 »

thanks for the replies guys.much appreciated.

15

Omega General Help / coolant level switch

« on: 04 May 2018, 08:43:29 »

hi everyone after a bit of advice please.car takes about 5mins to get to normal temperature before fans kick in.used to take longer than this or am i imagining it?.the low coolant level message appears on display only when it gets to normal temp but there is never any coolant missing!?. been doing this a couple of weeks now nb.this has only happened since changing cam cover gaskets.is it a coincidence or have i left maybe a vacuum pipe off.any ideas?.