I need help with the old model of Omega in 1995.
I have Opel Omega b produced in 1995. The engine is a 2.0 16V, code X20XEV power of 100 KW.
The problem is that non-stop lights the lamp of fault on the engine, and an error in the diagnosis shows that the camshaft sensor is defective. Specify this is a mistake that shows:
"My Naff Code Reader" 100219 - PC-based diagnostic tool
"My Naff Code Reader" - KW82 Communication Window> 1995 (S) | Omega-B | Engine | X 20 XEV
KW82 protocol is initialized.
ECU ID = NT, 90492433,2514b, 03A06b, 02,
Total number of fault codes: 1
00092 - Camshaft Position Sensor Circuit Range / Performance
Intermittent
Everything is examined in relation to the sensor, has the resistance which the manufacturer stipulates meaning that is totally correct. Installation connecting the sensor and computer also has been tested and it is correct. I even questioned the crankshaft sensor, which is also correct. The problem is that when the engine is turned on the lamp on the instrument panel went to the so-called '' safe mode '' and his power falls, it is much worse throttle response and consumes much more fuel, and the engine speed can not over 3500 rpm. To avoid any confusion changed the computer, Immobiliser with the key and after that again appears the same error. Changed the sensor and camshaft although existing correct ...
When via diagnostics delete the error that occurs, then there is no problem until the next ignition engine when immediately after power is displayed on the instrument panel. I noticed that when you suddenly turn off and re-start the engine in a split second when the engine is still in revs means turn and cut the engine just for a split second so that he continues to work, the light on the board goes off, and the engine runs great again until the next engine shut down when during the ignition again returns an error that I have listed above.
Please advice what to do ??