Omega Owners Forum

Chat Area => General Car Chat => Topic started by: 05omegav6 on 12 April 2014, 17:26:24

Title: Insignia Diagnostic socket Pin outs required
Post by: 05omegav6 on 12 April 2014, 17:26:24
As above please...

Specifically looking to identify Can Hi and Can Lo. Car is a 2013 2.0 cdti 130 manual if that has a bearing :-\

Ta muchly :y
Title: Re: Insignia Diagnostic socket Pin outs required
Post by: iainb on 12 April 2014, 17:40:36
http://connector.pinouts.ru/16_pin_car_J1962_OBD_2_special/         Try this link.
Title: Re: Insignia Diagnostic socket Pin outs required
Post by: 05omegav6 on 12 April 2014, 17:45:14
http://connector.pinouts.ru/16_pin_car_J1962_OBD_2_special/         Try this link.
Ta, but doesn't list the Insignia :-\
Title: Re: Insignia Diagnostic socket Pin outs required
Post by: RobG on 12 April 2014, 18:00:11
Pin 6 should be high, pin 14 should be low going by the "standardised" pin layout
Title: Re: Insignia Diagnostic socket Pin outs required
Post by: iainb on 12 April 2014, 18:13:31
ISO 15765 CAN (250kbit/sec or 500kbit/sec)
 pin 6: CAN High
 pin 14: CAN Low
 Used in most modern vehicles
Title: Re: Insignia Diagnostic socket Pin outs required
Post by: Taxi_Driver on 12 April 2014, 18:57:31
Your not trying to fiddle your meter are you Al  ::) ;D
Title: Re: Insignia Diagnostic socket Pin outs required
Post by: 05omegav6 on 12 April 2014, 19:21:05
Most certainly not ::) merely planning ahead... Just needed to identify which wire currently attached  does what :y

Thanks btw :y