Finally got both of the Autoleads cables and got round to fitting them today.
Not all went as I had hoped......
1. the memory did not work until I switched the fuse on the back of the hu to the other position, but this means that the unit is always live [smiley=huh.gif]
2. the cable did not solve the display problem, but one of the wires had an inline bullet connector - once disconnected the display was restored, but the steering wheel controls do not now illuminate [smiley=sad.gif]
3. the plugs on the autolead that connect to the vehicle harness were in two pieces and did not therefore fit onto the single vehicle plug without some modifications (namely hacksaw and craft knife!) [smiley=shocked.gif]
4. the steering wheel controls, though not illuminated, work perfectly [smiley=happy.gif]
There may have been something else, but I can't decide whether I'm happy or sad overall. I guess the cheaper cable and moving of the fuse would have solved the memory issue, and perhaps the display (?) and saved some money, but then again I have the benefit (?) of remote control which would have been unachieveable without the expense........ ah well the joys of motoring......... [smiley=thumbsup.gif]