Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - DavidF

Pages: [1]
1
Omega General Help / Re: Oil leak from top of engine on 2.2 doc Omega
« on: 17 September 2018, 09:34:18 »
Update! Checked the two pipes from the front of the cam cover and no blockages but the narrower one had a severe case of Brewers' droop: very soft and spongy so have advised father in law to buy a replacement and it is very easy to replace so he can do that. The good news is that his initial observation that the leak "was still there" was incorrect and only a minute drip of oil is found on his garage floor in the mornings so have decided to let sleeping dogs lye and monitor the situation. Many thanks for all the replies, especially those with photos. Now off to try and repair his key fob....

2
Omega General Help / Re: Oil leak from top of engine on 2.2 doc Omega
« on: 10 September 2018, 14:26:17 »
lots of replies/help: As I said earlier, I didn't check the two tubes heading for the throttle/intake manifold area. Waiting for the car to come back to me this week and can't wait to see inside the tubes!

3
Omega General Help / Re: Oil leak from top of engine on 2.2 doc Omega
« on: 07 September 2018, 13:13:45 »
The main breather tube and pipe on the passenger side was fairly clean when I re-sealed the gasket but I must admit, I didn't check the two at the front of the cover so they're first on my list. Thanks for your replies, I'll keep you updated.

4
Omega General Help / Oil leak from top of engine on 2.2 doc Omega
« on: 07 September 2018, 11:21:15 »
I've joined the forum as I have a problem with my father-in-law's 2.2 Omega: The usual oil leak from the top, rear (passenger side) of the engine. Yesterday I changed the cam cover gasket (Copy, not Vaux original as he had already bought one) which was obviously faulty as all sparking plug ports were FULL of oil once I removed the HT pack (1/4 of a cup of oil syphoned off!). Cleaned everything up and ran silicon gasket seal along seal area as well (belt and braces), new screw "O" rings and didn't over tighten the bolts. Removed oil breather pipe to block and applied silicon to gasket before re-fitting. On start up noticed a small drip from behind lower exhaust manifold bolt dripping onto block by the oil breather pipe. Using a mirror, a small amount of oil appeared to be coming from either the head gasket (Unusual) or the housing which the EGR valve bolts to, then running down the head to the exhaust bolt. I thought this might be old oil so cleaned area then started up again. Ran engine for 30 mins with no leaks and whilst doing so, used a mirror to check rear of head and confirmed no oil from cam cover or head nor any running down head towards ex' manifold. Turned off, let it cool down, then re-ran until fan cut in, again no leaks. Left over night and again no leak. Father-in-law collected car this morning and drove home (8 miles), just 'phoned to say oil leak in same place!!! I doubt the head gasket would blow just to release oil (the engine runs smoothly on all four cylinders) and wouldn't suspect the EGR valve "manifold" would contain oil so am somewhat confused. Anyone any ideas of common faults? Thanks in advance...

Pages: [1]

Page created in 0.02 seconds with 20 queries.