76
Omega General Help / Info r/e part
« on: 15 February 2011, 20:18:16 »
Plastic cover above grill you remove to access headlight bulbs is there a name for it? Mine snapped
- 28 April 2024, 18:58:54
- Welcome, Guest
News:
Please play nicely. No one wants to listen/read a keyboard warriors rants....
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
77
Omega General Help / Oil Level check light
« on: 09 February 2011, 16:21:31 »
Now on constantly despite oil level being full. Possible faulty sensor or wiring fault. Anyone know were the wiring runs to and can it be replaced if faulty. cheers in advance
78
Omega General Help / oil check warning
« on: 05 February 2011, 12:59:37 »
Just got the miggy back after having a new cylinder head fitted. Running well. But when I start the car I get check oil level coming up, although I know there is plenty of oil. Is there something that could be reset or what is there a fault with a gauge?
79
Omega General Help / Thats it Miggy's in the hospital.
« on: 13 January 2011, 15:37:33 »
Well no exactly in casualty awaiting new cylinder head gasket.
80
Omega General Help / Cylinder head gasket knackered.
« on: 12 January 2011, 12:58:41 »
Was advised to remove spark plugs and turn it over and watch for spouts of coolant. Well done this and Cylinder 4 was like a fountian. Waiting to get it towed to garage. All A need just after xmas.
81
Omega General Help / heater bypass valve location facelift
« on: 10 January 2011, 22:57:19 »
Is the heater bypass valve located in the same place behind the scuttle on the facelift. as it is on the V6?
82
Omega General Help / Advice needed please.
« on: 10 January 2011, 16:33:04 »
Yesterday I put up a post regarding misfire 4. was advised to check plug holes for oil water etc. Appears to be dry so other possible solution is coil pack. Filled up cooling level as it appeared I was at it. Was out in the car today small journey excessive exhaust fumes and coolent loss again. any ideas. Would the misfire contribute to this and should I go for a coil pack.
83
Omega General Help / Code advice please.
« on: 09 January 2011, 18:32:39 »
Just came home from hospital visit and EML light came on put a reader on it and got. P0304 Present
( 2 ) Cylinder 4 Misfire Detected. any advice where to start. Cheers in advance
( 2 ) Cylinder 4 Misfire Detected. any advice where to start. Cheers in advance
84
Omega General Help / torque converter
« on: 27 October 2010, 23:39:43 »
When driving I feel as if my clutch is slipping on my 2.2 cd auto. having read that it is a torque converter could this be the problem. Not very clued up on this field. cheers in advance
85
Omega General Help / Paint code advice.
« on: 13 September 2010, 08:38:35 »
Anyone know if there is a noticable difference in paint code L147 Star Silver II and Z157 Star Silver III. Not for touch up but for a wing.
86
Omega General Help / Wing advice please.
« on: 12 September 2010, 22:19:31 »
Was looking on Flea bay and came across a VAUXHALL OMEGA B FRONT RIGHT WING. Ad states it will fit all Omegas 1994 - 1999. Will this fit my 2003 CD Facelift thought I read they were all the same. Cheers in advance. :question
87
Omega General Help / Code help Please.
« on: 09 September 2010, 11:47:07 »
Just stuck a code reader on the miggy and got this
Total number of fault codes: 1
P1555 - Throttle Position Sensor (TPS) Load Signal not Plausible with Engine Load.
What does it mean. :question
Total number of fault codes: 1
P1555 - Throttle Position Sensor (TPS) Load Signal not Plausible with Engine Load.
What does it mean. :question
88
Omega General Help / Gasket info needed.
« on: 09 June 2010, 18:24:55 »
Have been searching the net also contacted a few company's without any help. Looking for an exhaust flange gasket for my 2.2cd. Unsure if it is flange or conical. Anyone replaced theres lately and can point me in the right direction also bore size if possible. Cheers in advance.
89
Omega General Help / Just changed the cat and full exhaust
« on: 08 June 2010, 19:45:33 »
Cat was burst and some holes in exhaust so had to replace it, now drives like and old coo noisy as hell but cannot find anything wrong at the joints except were the cat joins the mid section couldnt find any gasket online so just used instant gasket could this be the problem. Anyone point me in the right direction and size of gasket for this.
90
Omega General Help / what size is the exhaust clamp
« on: 03 June 2010, 22:28:46 »
what size is the exhaust clamp for back section to mid dark to jack it up and dont wanna have to buy a bundle of them anyone any idea what size. Cheers in advance