1
Omega Electrical and Audio Help / Re: Centre console boot release
« on: 08 September 2010, 16:11:07 »
Just to be sure. do you press and hold the button a few seconds?
- 05 May 2024, 10:37:22
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Omega Electrical and Audio Help / Re: facelift saloon: how do you open boot without key
« on: 18 September 2010, 12:51:49 »Quote
QuoteIt doesn't need the key in the ignition.
You have to press, and hold for about 3 seconds, before the boot pops open.
Took me a while to discover that 'feature'.
Why they didn't print '3sec' on the button beats me....
do you mean the button in the car or on the keyfob? none of the buttons on my keyfob now work so guessing its battery has just given up
The button in the car
3
Omega Electrical and Audio Help / Re: Russian Airbag testing
« on: 25 September 2010, 21:34:02 »
Can be a good Ejection seat 
4
Omega Electrical and Audio Help / Re: Wassat?
« on: 04 September 2010, 23:26:17 »
probably an old cellphone headset antenna connection
5
Omega Electrical and Audio Help / Re: car overheating at speed
« on: 04 September 2010, 23:21:20 »
probably Blocked radiator
6
Omega Electrical and Audio Help / Re: fuse blown :(
« on: 24 August 2010, 23:51:45 »
Shorten to earth is the wrong way it's better to check with a meter or lamp. Don't need to get every one out there's a user manual details the use of a fuse. so just check the relevent one
7
Omega Electrical and Audio Help / Re: Poor AM Reception
« on: 07 August 2010, 22:49:09 »
Did you pulled out the radio lately? Check the antenna connection & cable
8
Omega Electrical and Audio Help / Re: Single din audio connector for the Omega
« on: 26 July 2010, 19:39:04 »Quote
I'm about to put in a JVC single din unit in my car, and was given what I think is a 'iso' connector adaptor for connecting up the unit.You will also need a short antenna cable a female like TV's to male for the JVC side
However, whilst it's freely given to me, I need some advise if it would work on a 2001 model Omega. It's a Halfords PC2-04-4 model, and states that it'll work for "Vauxhall Astra, Calibra, Cavalier (88+) Corsa, Frontera, Nova (86+), Sintra, Vectra".
My question is would it work for the Omega, or do I need to get a different adaptor ?. As don't want to make an asumption that'll work ?.
If not, were would the best place be to get a proper adaptor lead ?.
Also want to get rid of the steering controls, so rather than simple remove them, and cut the wires, is there another vauxhall model, where I could simple swap the stereo controls / horn push loom, for a simple loom where just works the horns, but plugs into the Omega plug (if that makes sense) ?.
Thanks.
9
Omega Electrical and Audio Help / Re: NCDC 2013 eject
« on: 04 July 2010, 10:40:21 »Quote
On, and everything else works perfectly, just the ejects & on/offtry to Dismantle the front panel and see if it ejects.
if not you probably have torn Rubber band inside.
10
Omega Electrical and Audio Help / Re: ELECTRICAL FAULT...ADVICE REQUIRED.
« on: 04 July 2010, 11:10:47 »
don't tempt to cheap, can be a lot of other problems. end up expensive deal. look for a runing one.
11
Omega General Help / Re: Oil leak - advice
« on: 28 October 2010, 15:11:15 »Quote
It's easier to remove the gearbox and flywheel leaving the engine in place. A garage would book you maybe 10 hours to fit a replacement crank seal.
TNX
12
Omega General Help / Re: Oil leak - advice
« on: 28 October 2010, 08:44:51 »
The Cam cover is dry I think it's the rear crank seal.
and I ask again
what to dismantle engine or gear to change the oil seal?
how much working hours needs for that kind of job?
and I ask again
what to dismantle engine or gear to change the oil seal?
how much working hours needs for that kind of job?
13
Omega General Help / Oil leak - advice
« on: 27 October 2010, 23:32:43 »
Found a new oil leak, between the engine to the auto gear box.
what to dismantle engine or gear to change the oil seal?
how much working hours needs for that kind of job?
what to dismantle engine or gear to change the oil seal?
how much working hours needs for that kind of job?
14
Omega General Help / Re: Engine cutting out- Help!!!
« on: 25 October 2010, 10:54:54 »
If you have a low fuel in tank try to fill full. if helps check fuel pump and pressure
15
Omega General Help / Re: Not starting first time in the morning
« on: 16 October 2010, 12:58:55 »
If you also have problems driving on low fuel. I suggest also to check fuel pressure, had the same problem at starting. solved by changing fuel pump