Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: humbucker on 20 September 2016, 19:37:48
-
I've searched the forum and found loads of posts asking the question, but no actual answer to the brain-teaser that is 'how do you remove an Omega's manual gear knob if you want to replace it with an aftermarket/Irmscher item?'
Any ideas? :-\
-
Gear stick already out of the car btw
-
put it in a vice and yank it off, providing its a lift reverse
-
Just pull it off.
-
it has to be cut off with a hacksaw, there was a guide on the irmscher site a while back.
-
it has to be cut off with a hacksaw, there was a guide on the irmscher site a while back.
Is that the plastic bit left after the knob falls off?
The shaft is knurled to grip the knob
-
Just be carefull that you dont pull the reverse lever with it as your stretch and ruin the plastic attachment that lives inside the lever itself. Got that T Shirt. :-[
-
Same principle as this? https://www.youtube.com/watch?v=me4RIH_DcGY
-
No just cup it in both hands and pull it off