1
Omega General Help / Front strut spring identifcation
« on: 26 August 2025, 17:04:07 »
I currently have the front suspension stripped on my 2002 3.2 Elite saloon ready for replacement with new GM struts, wishbones, drop links etc. The struts are ident LM / RP which are GM 919949 /50, with springs with two brown blobs on them (I assume are 90541754).
The bottom rubber insulator is quite perished / cracked, and I have checked t'interweb, but no one seems to supply them. I have new bump stops, top mounts / bearings etc ready to fit.
Does anyone know a source of the bottom insulator rubber?
Secondly, I have a good set of complete GM front struts that I took off a late TVP 3.2 estate with self levelling rear suspension several years ago. They were obvious recent GM replacements along with GM wishbones, drop links etc. They have the ident LP / RP which are GM 9192291 /2, which are NLS, so the EPC lists replacement part no. 919949 /50 as suitable.
However the Police springs are different - they have 5 1/2 full coils with orange / green paint blobs, where as the ones off my car have 6 coils and two brown blobs. The Police are marginally thicker but so negligible my manual vernier caliper doesn't indicate how much but I would say 0.2mm??
The question is - does anyone have any info on the colour coding on the Police front springs, and if I fit the complete Police struts, how would it affect the front end? There are obvious differences according to the minefield in the EPC, but what? I can only presume they are firmer, but without any info, who knows?
Thanks anyway.
The bottom rubber insulator is quite perished / cracked, and I have checked t'interweb, but no one seems to supply them. I have new bump stops, top mounts / bearings etc ready to fit.
Does anyone know a source of the bottom insulator rubber?
Secondly, I have a good set of complete GM front struts that I took off a late TVP 3.2 estate with self levelling rear suspension several years ago. They were obvious recent GM replacements along with GM wishbones, drop links etc. They have the ident LP / RP which are GM 9192291 /2, which are NLS, so the EPC lists replacement part no. 919949 /50 as suitable.
However the Police springs are different - they have 5 1/2 full coils with orange / green paint blobs, where as the ones off my car have 6 coils and two brown blobs. The Police are marginally thicker but so negligible my manual vernier caliper doesn't indicate how much but I would say 0.2mm??
The question is - does anyone have any info on the colour coding on the Police front springs, and if I fit the complete Police struts, how would it affect the front end? There are obvious differences according to the minefield in the EPC, but what? I can only presume they are firmer, but without any info, who knows?
Thanks anyway.
!) or good used.
. I hung around as no one else had witnessed it, or could say who the driver was. The 'after the event witnesses' soon appeared. Funny how people who have no idea how to handle a situation such as this want to get involved....

).