My reversing lights do not work Checked bulbs and fuse all ok.I suspect the switch which I believe is on the gear box or a broken wire in the boot corner,Any idea of wire colour for this,
After sitting in this hot weather for a few days the car turned over very slowly and then built up to normal could this be vapourisation in the pipe work. Once started it has been ok.
I am having problems with the drivers lock in that when I unlock with the remote the button stays down all others are ok.I lift the button manually and then it will operate perfectly several times with no problem.I leave the car some time and once again the button stays down. I have tried to lubricate via the latch, one bolt removed but no better.Any ideas.
What is thought to be the best lubricating spray for door lock mechanisms.My replacement front lock,used, seems to be sticking. I sprayed it with PTFE spray before fitting.
Having put a new second hand lock drivers side front in a little while ago I have problems again. When I first fitted the lock when I unlocked the door with the remote the lock opened and immediately shut after a few tries it cured itself. Now it is happening again and I have to unlock with the key this time after several tries with the remote it continues to lock itself Any ideas
This is a known area for wire breakage after continual flexing mine has failed twice , soldered joints are too rigid and soon fail.Is it best to insert a long length of wire so that the joint is away from the hinge or has someone found a better cure.
Ordered a new barrel yesterday as mine was sticky today key wont turn.What do I do now. Drill out the barrel if so how deep? I now have a jammed drivers lock and a jammed ignition barrel. Any body want an Omega
My door will not open the locking system is working ok as is the key method of locking.I feel sure that it is a rod to the lock that has become detached .the outside handle and the inside handle do not release the lock. Any ideas before smashing the door card to access the lock etc..All help gratefully received.
where can I get rear brake pad pins for my 03 2.6 saloon vented disc.They appear to be difficult to find. Anybody know the pin length to save be taking the wheel off.
I have just fitted a new pollen filter made my Crossland.The Gm one I took out had an air flow direction arrow,the new one doesn't.Does it matter which way it goes in.
What are the recommendations on rust treatments I treated a small section on my wheel arch about 6 months ago and the rust is showing through again. I used Loctite rust remedy and cleaned as much rust off as possible.I know cut out the area and weld but this is a very small section.