Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - pirate

Pages: 1 2 [3] 4
31
Omega General Help / aluminium headlight adjusters
« on: 18 September 2011, 19:58:07 »
enyone got a spare pair of adjusters guy on here who sells them is away till the 26 th ive now got two pairs of headlights all with broken adjusters stripped the ones out to do repair now stuck ,eny thoughts as a bit peed of now,
thanks folks :(

32
Omega General Help / parts help
« on: 11 September 2011, 20:11:09 »
not got enough post yet .
im needing a mint auto leather gaitor for shift stick
mint gaitor for handbrake,
also two black plastic plugs that cover plenium cover bolts.
and on off side turn clip that holds the trim above headlight ,the plastic trim which runs accross eng bay above rad. this is on a pre face lift t reg elite steinmetz est

thanks folks

33
Omega General Help / standard ride hight
« on: 10 July 2011, 17:24:24 »
can some one tell me or go mesure there elite estate i want to see if mine sits high at the back mines a pre facelift on a t reg ,she has had the air shocks removed and new springs and bilstein shocks fitted at the back, im lwanting to stiffen up front but dont want to lower to much as steinmetz body kit up front is low, at the moment front is 67 cm to arch and rear is 69 cm is this about right ?

34
Omega General Help / new uprated springs
« on: 25 May 2011, 19:17:14 »
best place to get uprated springs for my steinmetz elite estate as fronts getting tired dont want more than 30 mm drop as body kit is low. :-?

35
Omega General Help / springs
« on: 29 April 2011, 19:40:58 »
i want to stiffen up my steinmetz elite estate , rear has been converted to bilsteins and standard springs and is alot better but front is to soft i dont want to lower her because of body kit and the state of the roads ,
q, would fitting mv6 springs front and back do the job or after market springs which all seem to lower her by 30 mm.
 8-)

36
Omega General Help / vibration at speed
« on: 02 April 2011, 19:33:51 »
fitted new discs and pads up front had front wheels rebalenced  .at local speeds fine but have noticed vibration over 75 on the motorway, when i fitted new discs i noticed one had a machined slot though the cooling fins on edge  of discs is this how it was balenced or do you guys think ive a duff disc as ive never seen this before, the whole car had complete 4 wheel tracking done by previus owner after new rear shocks and springs 1 year ago , ?

37
Omega General Help / poor heater
« on: 30 March 2011, 20:41:02 »
have flushed and checked though coolent  ,reset heater control servo,s not very hot up front and rears are blowing cool air ? question 1 flush heater matrix next ,
              question 2 has somthing come adrift in centre console or under arm rest than controls heat to rear vents ?

38
Omega General Help / rear wheel bearing
« on: 07 March 2011, 19:14:14 »
not got a haynes, is there a rough guide to wheel bearings got to change nr side rear on the est weds eny thing i should watch out for or is it straight forward enough, :y

39
Omega General Help / front suspension upgrade
« on: 06 March 2011, 19:31:03 »
right sorting brakes out but where can i get uprated springs and or shocks for the front of my 2.5 v6 est as the front end handles like a saturn 5 booster rocket and i have to slow so much for speed bumps as the stienmetz body kit is low at the front, :D

40
Omega General Help / 2.5 v6 auto box
« on: 06 March 2011, 10:51:35 »
my 99 t reg omega elite steinmetz est ,am i right in thinking the auto box is a bmw ? also is it sealed like bmw or is there a dip or levels check ? 8-)

41
Omega General Help / poor heat from heater
« on: 28 February 2011, 18:03:31 »
may answer my own question , as there has been a flush of my coolent system by previus owner im guessing that heater matrix is bunged up as rad is clear and eng temp is spot on , what kind of flush would you guys rekomend or should i just fit new heater matrix, and i hope its not as hard to do as a range rover .

42
Newbie Welcome Area / steinmetz elite est
« on: 25 February 2011, 16:33:37 »
howd do folks ,ive gone over to the dark side ,got me a 1999 omega elite steinmetz estate few bits and bobs to do but generaly very good lots of service papers and old mots,will get afew pics up when ive done acouple of minor bits on her,have never seen one before very different and fully loaded ,enjoying the bose sound system and being able to turn off the tration control.ye ha 8-)

43
Omega Gallery / steinmetz elite est
« on: 06 May 2011, 22:02:12 »
gave her a clean done a few bits, next exhaust mod and lower and stiffen suspention.P4290004dont you had tech when it dont work , :(

44
Omega Gallery / steinmetz estate
« on: 23 March 2011, 19:44:30 »
hope this works dudes...


45
Omega Gallery / steinmetz elite est
« on: 23 March 2011, 19:48:25 »
another one 8-)

Pages: 1 2 [3] 4

Page created in 0.029 seconds with 17 queries.