Not yet.
Replaced items so far: Drier, expansion valve and ALL the O rings.
Compressor clutch appears to be working correctly, as best as can be tested ign on/aircon switch on off... Certainly feel a difference when it's engaged, but still smooth with no binding or pulley issues. From what I can gather, the compressor is constantly engaged with a bypass valve regulated by the climate panel.
I did pull the condenser to check both sides, and no evidence of any previous leaks.
It's possible that the new seals, although looked the same as what came out, may be too small/large. I did dip them in Pag 46 before fitting, so it isn't as though they were fitted dry.
Also it's a possibility that the low pressure connection to the compressor and the allen bolts than hold the expansion valve to the evaporator connection aren't quite tight enough but the torque setting is pretty low on the entire system... There's only so much torque you can put through a 3mm allen bolt into aluminium