1
Omega Electrical and Audio Help / Re: omega won’t start after change ecu
« on: 17 February 2017, 15:05:36 »
yes , i buy this pack
- 29 April 2024, 05:03:52
- Welcome, Guest
News:
Please play nicely. No one wants to listen/read a keyboard warriors rants....
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega Electrical and Audio Help / Re: omega won’t start after change ecu
« on: 17 February 2017, 13:49:50 »
I changed ECU because spark plugs didn’t give spark, they haven’t got absolutely any spark. I changed ignition coil, camshaft sensor and crankshaft sensor because I hoped it would help but it didn’t. Spark plugs and ignition cables are ok and cables from ECU is ok too, I checked it.
3
Omega Electrical and Audio Help / omega won’t start after change ecu
« on: 16 February 2017, 20:12:42 »
Hello
I had to change ECU in my Omega B and after that car won’t start. I changed immobilizer too which I bought with ECU. Moreover ‘’check engine’’ light doesn’t light, fuel pump doesn’t pump petrol into engine... After I connect "My Naff Code Reader", I can’t diagnostic engine but I can only immobiliser.
Opel Omega 2.0 16v X20XEV 1995 ECU Simtec 56 02
Fault codes:
15 Vehicle Speed Signal Voltage Low
17 No Engine Request Received
Can anyone help me with this problem? Thanks for answers.
Greetings from Slovakia.
I had to change ECU in my Omega B and after that car won’t start. I changed immobilizer too which I bought with ECU. Moreover ‘’check engine’’ light doesn’t light, fuel pump doesn’t pump petrol into engine... After I connect "My Naff Code Reader", I can’t diagnostic engine but I can only immobiliser.
Opel Omega 2.0 16v X20XEV 1995 ECU Simtec 56 02
Fault codes:
15 Vehicle Speed Signal Voltage Low
17 No Engine Request Received
Can anyone help me with this problem? Thanks for answers.
Greetings from Slovakia.
Pages: [1]