16
Omega General Help / Re: Geometry settings...whatdya reckon?!
« on: 30 April 2008, 23:25:37 »
Where is this BMTR place?
Search the maintenance guides for answers to 99.999% of Omega questions
QuoteAnyone know if these will fit an omega?....
http://cgi.ebay.co.uk/16-INCH-ALLOYS-VAUXHALL-VECTRA-SRI_W0QQitemZ150241159800QQihZ005QQcategoryZ9888QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
They'll fit (i.e 110mm pcd 5 bolt pattern), but the offset will be ET45 or thereabouts being from a front wheel drive car. An Omega needs an offset of ET35-38.
You'll need spacers by Eibach / H&R and these will cost you roughly another £180 for the 2 pairs.
There's enough space under an Omega's arches to use +25mm spacer per corner at the rear and +16mm spacer per corner at the front.
These wheels are from a Vectra/Signum-C VXR...
What about an Omega Elite backbox as they have twin exit pipes???