Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: VXL V6 on 01 June 2021, 11:29:20
-
Morning!
Can anyone point me in the right direction for the following please?
Banjo bolts + washers
Caliper bracket to Hub bolts
-
You'll find them at the front of your car, adjacent to the wheels, on both sides.
No need to thank me :)
-
Technically, you'll also find them on the rear.
Try Bigg Red. Then probably be able to help with banjo and washers, but probably not the carrier to hub bolts.
-
Technically, you'll also find them on the rear.
Try Bigg Red. Then probably be able to help with banjo and washers, but probably not the carrier to hub bolts.
Cheers, I sent them an email this morning so hopefully will get a response this week. :y
-
Just Google 10mm Banjo Bolt, they're available from all sorts of places for very little money.
I suspect the caliper bolts use a specific sized shank, and will probably be Vx only. A quick check with a digital caliper will confirm that.
-
SKT.SCHRAUBE M12X40 Opel Ersatzteil 0543218 90541296
Was it this and with 18mm spanner
-
Looks about right for the bolts.
Why aren't you reusing them?
-
Looks about right for the bolts.
Why aren't you reusing them?
This. Clean them up, re-thread lock and torque to spec. Also, if you're going to this much trouble, why not change the nipple too? Also make sure you have a nipple cover, it helps to stops them rusting in
-
Looks about right for the bolts.
Why aren't you reusing them?
This. Clean them up, re-thread lock and torque to spec. Also, if you're going to this much trouble, why not change the nipple too? Also make sure you have a nipple cover, it helps to stops them rusting in
Well if it was that easy I wouldn't be asking the question :D
Yep have replacement bleed nipples already for them :y
The existing calipers are Brembo 18Z six pots that are going to be used elsewhere, the used pair of calipers I have been refurbishing to fit are missing the specified bolts :y
It's all part of a long term plan 8)
-
Details ;D
When the time comes, swapsy swapsy.
What do the Brembo calipers use to attach to the knuckle?
-
Looks about right for the bolts.
Why aren't you reusing them?
This. Clean them up, re-thread lock and torque to spec. Also, if you're going to this much trouble, why not change the nipple too? Also make sure you have a nipple cover, it helps to stops them rusting in
Well if it was that easy I wouldn't be asking the question :D
Yep have replacement bleed nipples already for them :y
The existing calipers are Brembo 18Z six pots that are going to be used elsewhere, the used pair of calipers I have been refurbishing to fit are missing the specified bolts :y
It's all part of a long term plan 8)
He's got a big brake kit from our Polish wizard ;)