Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - tango

Pages: [1] 2 3 4 5 6 7 8 ... 25
1
As title
Just removed the complete towbar of facelift saloon
For sale
Not sure on price , what’s it worth 
Other omega bits also coming as im breaking elite car soon
Genuine VX ones were less than £200 new.
don’t think it’s genuine
I’m
Open to offers , collection from Bham

2
You should have a pm..... :y
replied 👍

3
Car Parts, bits For Sale & Wanted / Saloon towbar for sale
« on: 02 May 2024, 09:52:53 »
As title
Just removed the complete towbar of facelift saloon
For sale
Not sure on price , what’s it worth 
Other omega bits also coming as im breaking elite car soon

4
Omega General Help / Re: 2003 2.6 read drivers side calliper
« on: 17 August 2020, 23:37:08 »
Thanks everyone
I’ll inspect the calliper and will Change the discs and pads on both sides while im at it

5
Omega General Help / Re: 2003 2.6 read drivers side calliper
« on: 17 August 2020, 16:12:40 »
Could i be lucky and push the pistons back in
Fit new vented discs and good to go
Or is the calliper damaged and seals have to be changed

6
Omega General Help / Re: 2003 2.6 read drivers side calliper
« on: 17 August 2020, 15:15:32 »
Ok
So looks like previous owner has put in wrong discs

7
Omega General Help / Re: 2003 2.6 read drivers side calliper
« on: 17 August 2020, 14:18:08 »
I need rear
have solid discs on the rear

8
Omega General Help / Re: 2003 2.6 read drivers side calliper
« on: 17 August 2020, 13:44:07 »
2.6
Solid discs
Calliper has no.42 on it
The one I bought from euro had 40 stamped on it

9
Omega General Help / Re: 2003 2.6 read drivers side calliper
« on: 17 August 2020, 13:29:42 »
V6
Just need the drivers side tbh

10
Omega General Help / 2003 2.6 read drivers side calliper
« on: 17 August 2020, 13:22:49 »
So my brake calliper started leaking
I ordered a new one from euro car parts
But it’s the wrong size and they’re Only got the one type
Any suggestions where i can get one from
Tia

11
Omega Electrical and Audio Help / Re: Ncdc2013
« on: 11 July 2020, 11:36:56 »
Got a few problems sorted
First of all the radio reception
I swapped the two red/white wires back of the stereo

Secondly the Earth strap under the car was completely knackered
So replaced that and cleaned up the one near the battery tray
I’m only getting 12.5v whilst car is started
So alternator could be on its way
Although don’t have any starting or charging issues


Sound not cutting out anymore fingers crossed
Still don’t know exactly what caused it


Rds time updates whilst I got it on a radio Channel
When I switch back to to cd changer And leave car it stops updating and falls back until I go back to a Rds station

But that’s not a issue right now I’m glad I got the sound problem resolved , I think

12
Omega Electrical and Audio Help / Re: Ncdc2013
« on: 07 July 2020, 20:50:23 »
Just another thought, when you removed the Bose from this car how did you re-route the outputs? Did you use a none Bose turnaround connector? The switched 12V for the rear audio components is derived from that connector.
The speaker output wires in the loom at the back of the stereo Have a black tubing around them
The Bose units use these 8 wires to send a pre amp signal to the Bose amp
And then the Bose amp sends the amplified signal into the same colour co-ordinated wires in to the speakers
All I did was to couple the wires to the same colours
For the front speakers
And for the rear shelf I connected the the wires direct to the speakers
That’s left me with three wires
Power red
Ground brown
And 12v signal red/white
I just insulated them

13
Omega Electrical and Audio Help / Re: Ncdc2013
« on: 07 July 2020, 20:43:36 »
Reception issues usually down to damaged aerial cable / plug on the back of the Head Unit cage which happens when the cage has been in and out a few times, this also would account for the RDS clock setting not working.

The feed for the steering wheel controls is from the Headunit hence why they stay on on NCDC equipped cars for 5 or so mins after locking the car. Never seen the steering wheel control illumination have the problem you describe, sounds more like a problem on the loom / plug to the head unit.

Given the multitude of issues you are seeing might it be worth testing the alternator output and checking the earth straps - especially the one at the front of the engine.
Engine was replaced in the car few years back
Car was parked up for a few years
So maybe that’s something I can look into
But battery seems to charge fine and no other electrical issues

14
Omega Electrical and Audio Help / Re: Ncdc2013
« on: 07 July 2020, 14:24:00 »
Thanks I’ll give that a go
It’s definitely not the telemute wire

Also
I’ve noticed my radio reception seems to be on and off
Not in sync with the sound and off so a separate issue
The radio reception comes in and out and I’ve noticed that the buttons on the steering will light up when I’ve got reception
So now I’m thinking the the 12v signal provided to the radio Ariel also activated the steering button lights
What can cause this to pulse on and off like on for 1 second and then off for about 3 and then repeating
The time is also not setting itself with Rds


15
Omega Electrical and Audio Help / Re: Ncdc2013
« on: 06 July 2020, 22:51:04 »
I’ve already check this by disconnecting all channels and connecting one at a time

Pages: [1] 2 3 4 5 6 7 8 ... 25

Page created in 0.034 seconds with 19 queries.