Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[paul8594]

Hi, i have a 51 plate omega estate and bought a dealer direct detachable tow bar second hand from that certain auction place!

Finally got around to fitting it after lots of wire brushing, cleaning and repainting and noticed that after i tightened all the new bolts (stainless steel) the tow bar was bending the bottom of the bumper.

Have i got the brackets that go under the car between the tow bar and beams the wrong way around?

I put the brackets u side up so that they wrap around the beam and the plate / brackets fits back to back to the bumper.

Should they be turned the other way round so they are n side up so the bracket and beams are back to back as this would give me a little more depth and would possible miss the bumper.

Or do i just cut the bumper around the towbar?


Any help or comments would be appreciated

Paul

[Weds]

My bumper is bent as well with the tow bar. Just bolted it all in place with the bumper bent underneath, didn't fancy cutting it and making a mess of it..

[Andy B]

I'd be surprised if your bumper didn't require some sort of cut, my MFL saloon had a preformed  cut at the lower edge that just required 1/8" cut either side of a flap that I've just folded up out of the way.

Stainless fasteners are NOT a good idea, they're too soft. You need high tensile bolts.

[tigers_gonads]

I know on the pre facelift, they is a couple of score lines in the underside of the bumper which you cut and then bend it up and back.

[noel]

I'd be surprised if your bumper didn't require some sort of cut, my MFL saloon had a preformed  cut at the lower edge that just required 1/8" cut either side of a flap that I've just folded up out of the way.

Stainless fasteners are NOT a good idea, they're too soft. You need high tensile bolts.

x1

[jonathanh]

typically they need a bumper cut to fit

make sure you also remove any mastic in the boot between the mounting plate and the floor - if not the bar will come loose

[paul8594]

Thanks for all your replies, i think i will leave it as is, me and cutting straight lines do not mix!!!

As for the stainless steel bolts, i thought i was being clever as the ones that were fitted needed to be cut off with an angle grinder!

[Andy B]

Thanks for all your replies, i think i will leave it as is, me and cutting straight lines do not mix!!!

 .....

If it's like my saloon, you're only cutting aboout 1/8" on either side of the flap, then there's a 'scored' line that you fold along.