Hi all
Following a full issue with the local Vx main stealer at MOT time, I am suffering a problem with my headlights - the message
Low Beam Fld/Vision comes on the display and it keeps coming back so I assume the problem remains even after some fiddling to make sure the headlight end of the wiring is secure.
I did a quick search here and it brought up the normal sensor failure (nearside front and rear); for the MOT I am sure they would have been poking around in these areas but the actual culprit involved in the MOT failure was the inside front tie rod end - on the off-side.
I have never had any kind of problem to do with these sensors and within a week of the MOT and a replacement tie rod on the other side its FUBAR'd.
Have a few quick questions at the moment....
Could the garage have mistakenly/unknowingly done anything to bring this error up?
Should I be sending it back there for inspection? Keep in mind we had a falling out...
Finally, should Tech2 be used to find which sensor (if not both) have gone, or if the motors on the headlights are dead?
The fault means the range on my lovely HID's is about 10 feet, mabye less
Dammit all, was having a good May until the 2nd.
Thanks for reading,
Alex