Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Removing Steering tie rod help

« on: 01 October 2007, 19:14:26 »

I replaced the wishbones on the car and now as a result I need the tracking sorted. So of I went to get it done when they put it up on the lift and had a look they point blank refused to do it. Reason being is that apparatly the tie rods looks seized and last one they done broke. So now I am faced with removing them to free them up. Problem is after removing the two end nuts it will not budge at all. Is there something I'm missing?

2

Omega General Help / Mystery Vac pipe in engine bay

« on: 10 March 2007, 17:20:45 »

Just after changing the rocker gaskets and sorting out the mess of vacum pipes , managed to get everything in the right place following the diagram in the maintence section, however there is a slightly larger vac pipe that comes through the inner left wing along with the petrol pipes that I have no clue what its for or were it goes, anyone know were it is supposed to go?

3

Omega General Help / Vauxhall  Part no. required

« on: 16 February 2007, 12:24:25 »

Does anybody know the part number for the Vectra (metal) cam cover gaskets?

thanks

4

Omega General Help / putting cam sprockets back on

« on: 11 September 2006, 20:32:58 »

Just want to confirm that the notches should be aligned with the numbered cut outs , releating to what cam it is ie.

cam one points to number 1
cam two points to number 2


cam three points to number 3
cam four points to number 4


also a picture of the cam identifier if someone wants to put it in the other article

5

Omega General Help / identifying camshafts

« on: 09 September 2006, 15:44:22 »

Any way of knowing which is inlet and which is outlet ? Someone   I know forgot to label them as they were taken out lol

6

Omega General Help / Clutch friction plate

« on: 05 September 2006, 20:13:32 »

Can someone confirm that the way it goes in is with the side with the centre protruding goes towards the gearbox?
Want to make sure before lining and tightning it up

7

Omega General Help / Alternative to the green sealant

« on: 05 September 2006, 12:59:32 »

Is there anything I can use in place of the green vauxhall sealant 90 542 114 , as the dealer here does not have it in stock and will not order it for me, as apparantly it comes in boxes of 10 ?
cheers

8

Omega General Help / dented sump

« on: 03 September 2006, 16:41:42 »

How much of an issue will this be?


Would I get away with this or might it cause oil pickup problems

9

Omega General Help / 98 MV6 Clutch

« on: 01 September 2006, 09:44:53 »

Is it cable or hydrolic ?