91
General Car Chat / Re: Question about eBay seller
« on: 31 October 2013, 11:24:05 »
He's now updated the ad to include the MOT advisories, with some mention of the repairs..
Please check the Forum Guidelines at the top of the Newbie section
I have fitted the mv6 seat so I can repair the Elite seat later.
Fault is exactly as described. Seat upside down, follow the heated seat loom from the back until it disapears under the side frame next to another loom that also leads to the same place into the heated seat control unit.
The conduit had been cut through along with the insulation to reveal bare copper touching the side frame. The bit if tape vx fitted to cover the edge had unfolded itself out flat to leave the metal bare, which then cut through the wire when the seat is occupied.
I have to say, I find it disgracefull a fault like this can cause the engine, and hence pas and brake assistance to cut out.
Mine burst when I was 10 and I still remember the finger and the rubber glove...........
Glad you are ok now though.....
Nice pad you have there, Weds.
Incidentally, how much does a 1990 928 set you back these days? .
Mmm.. Always fancied one of those.
+1 Even the 4 pot ones go for a lot of dough
Lovely car , not envious at all
Is there such an animal as a 4 cylinder 928?.......I thought they were all blessed with a woofly V8.
fuel pumps,electrics, and they like fuel more than an omega.
The only porsche worth having.
Is there a how-to for replacement of rear wheel bearings? If so, I can't find it!
If not, can someone give me an indication as to where the best place is to get new bearings (ie. GM or pattern), how much I should be paying for them, and also whether this is a job best left to a garage or not?
TIA