Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[bigtow]

while jacking my car up the jack slipped and caught the level sensor the arm looks to still be connected the only thing i could see that looked damaged was the wires going to the sensor were looking squashed against the wish bone is the section of loom available or would it be best to repair it ?

[doz]

Repair. From Memory it is on piece back to the controller in the O.S. Wing. Only 3 wires. However if you haven't had the fault come up on the display you may of got lucky

[bigtow]

thats how i know i have damaged something as i have the fld/vision message of doom 

[doz]

Took me bloody hours to suss out what was wrong with mine. Had two broken wires touching together getting me right in a pickle. Best break out the soldering iron

[bigtow]

Best break out the soldering iron

so a couple of bullet connectors and sticky tape wont work then ? lol

[doz]

Only if you use 2.5 mm twin and earth house wire 

[bigtow]

dont tempt me 

[kooky_guy]

Excuse the thread hijack - I picked my car up from the garage yesterday - they replaced the thermostat.

It immediately showed this error as soon as it started. Anything obvious for me to check?

[Andy B]

.....

It immediately showed this error as soon as it started. Anything obvious for me to check?

Often the arm pops off the sensor on the front nearside wishbone. 

[kooky_guy]

.....

It immediately showed this error as soon as it started. Anything obvious for me to check?

Often the arm pops off the sensor on the front nearside wishbone. 

Would they have been anywhere near this to replace the thermostat? It did takle them a week, I suppose...

The worrying thing is that the fault seems to pop up intermittently. or is that normal for this fault?

[Andy B]

.....

Would they have been anywhere near this to replace the thermostat? It did takle them a week, I suppose...

Nowhere near 

The worrying thing is that the fault seems to pop up intermittently. or is that normal for this fault?

Mine came on & stayed on till I replaced the front sensor years ago & hasn't been back on since. Try a squirt of switch cleaner in the plug/socket 

[CaptainZok]

GLS won't have level sensors will it?

[Andy B]

GLS won't have level sensors will it?

I suppose it must have if the field vision warning is on ..... 

[RobG]

Doubt it. OP`s profile states GLS 2.6. No such beast, must be a typo (or typographical error for you Andy)

[Andy B]

.....
No such beast, must be a typo (or typographical error for you Andy)

Now come on Rob! I only pick up on bloody Americanisms & those that are plain stupid!