Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Figureman52 on 29 April 2021, 14:24:21
-
Is there any way to check the connection of the spade connector on the sender for the temp gauge without removing the plenum etc?
It may or not be relevant, but I had the cam cover gaskets replaced last November but due to lack of use have only just noticed the gauge isn’t working. :-[
What else might cause the gauge to stop working?
Thanks.
-
Might be able to see with a mirror on a stick. It only takes a few minutes to take the plenum off though.